#define IFF_LOOPBACK 0x8 /* is a loopback net */
#define IFF_POINTOPOINT 0x10 /* interface is has p-p link */
#define IFF_NOTRAILERS 0x20 /* avoid use of trailers */
-#define IFF_RUNNING 0x40 /* interface running and carrier ok */
+#define IFF_RUNNING 0x40 /* interface RFC2863 OPER_UP */
#define IFF_NOARP 0x80 /* no ARP protocol */
#define IFF_PROMISC 0x100 /* receive all packets */
#define IFF_ALLMULTI 0x200 /* receive all multicast packets*/
#define IFF_MULTICAST 0x1000 /* Supports multicast */
-#define IFF_VOLATILE (IFF_LOOPBACK|IFF_POINTOPOINT|IFF_BROADCAST|IFF_MASTER|IFF_SLAVE|IFF_RUNNING)
-
#define IFF_PORTSEL 0x2000 /* can set media type */
#define IFF_AUTOMEDIA 0x4000 /* auto media select active */
#define IFF_DYNAMIC 0x8000 /* dialup device with changing addresses*/
+#define IFF_LOWER_UP 0x10000 /* driver signals L1 up */
+#define IFF_DORMANT 0x20000 /* driver signals dormant */
+
+#define IFF_VOLATILE (IFF_LOOPBACK|IFF_POINTOPOINT|IFF_BROADCAST|\
+ IFF_MASTER|IFF_SLAVE|IFF_RUNNING|IFF_LOWER_UP|IFF_DORMANT)
+
/* Private (from user) interface flags (netdevice->priv_flags). */
#define IFF_802_1Q_VLAN 0x1 /* 802.1Q VLAN device. */
#define IFF_EBRIDGE 0x2 /* Ethernet bridging device. */
+#define IFF_SLAVE_INACTIVE 0x4 /* bonding slave not the curr. active */
+#define IFF_MASTER_8023AD 0x8 /* bonding master, 802.3ad. */
+#define IFF_MASTER_ALB 0x10 /* bonding master, balance-alb. */
#define IF_GET_IFACE 0x0001 /* for querying only */
#define IF_GET_PROTO 0x0002
#define IF_PROTO_FR_ETH_PVC 0x200B
#define IF_PROTO_RAW 0x200C /* RAW Socket */
+/* RFC 2863 operational status */
+enum {
+ IF_OPER_UNKNOWN,
+ IF_OPER_NOTPRESENT,
+ IF_OPER_DOWN,
+ IF_OPER_LOWERLAYERDOWN,
+ IF_OPER_TESTING,
+ IF_OPER_DORMANT,
+ IF_OPER_UP,
+};
+
+/* link modes */
+enum {
+ IF_LINK_MODE_DEFAULT,
+ IF_LINK_MODE_DORMANT, /* limit upward transition to dormant */
+};
/*
* Device mapping structure. I'd just gone off and designed a
#define ifc_buf ifc_ifcu.ifcu_buf /* buffer address */
#define ifc_req ifc_ifcu.ifcu_req /* array of structures */
+/* The struct should be in sync with struct net_device_stats */
+struct rtnl_link_stats
+{
+ __u32 rx_packets; /* total packets received */
+ __u32 tx_packets; /* total packets transmitted */
+ __u32 rx_bytes; /* total bytes received */
+ __u32 tx_bytes; /* total bytes transmitted */
+ __u32 rx_errors; /* bad packets received */
+ __u32 tx_errors; /* packet transmit problems */
+ __u32 rx_dropped; /* no space in linux buffers */
+ __u32 tx_dropped; /* no space available in linux */
+ __u32 multicast; /* multicast packets received */
+ __u32 collisions;
+
+ /* detailed rx_errors: */
+ __u32 rx_length_errors;
+ __u32 rx_over_errors; /* receiver ring buff overflow */
+ __u32 rx_crc_errors; /* recved pkt with crc error */
+ __u32 rx_frame_errors; /* recv'd frame alignment error */
+ __u32 rx_fifo_errors; /* recv'r fifo overrun */
+ __u32 rx_missed_errors; /* receiver missed packet */
+
+ /* detailed tx_errors */
+ __u32 tx_aborted_errors;
+ __u32 tx_carrier_errors;
+ __u32 tx_fifo_errors;
+ __u32 tx_heartbeat_errors;
+ __u32 tx_window_errors;
+
+ /* for cslip etc */
+ __u32 rx_compressed;
+ __u32 tx_compressed;
+};
+
+/* The struct should be in sync with struct ifmap */
+struct rtnl_link_ifmap
+{
+ __u64 mem_start;
+ __u64 mem_end;
+ __u64 base_addr;
+ __u16 irq;
+ __u8 dma;
+ __u8 port;
+};
+
+enum
+{
+ IFLA_UNSPEC,
+ IFLA_ADDRESS,
+ IFLA_BROADCAST,
+ IFLA_IFNAME,
+ IFLA_MTU,
+ IFLA_LINK,
+ IFLA_QDISC,
+ IFLA_STATS,
+ IFLA_COST,
+#define IFLA_COST IFLA_COST
+ IFLA_PRIORITY,
+#define IFLA_PRIORITY IFLA_PRIORITY
+ IFLA_MASTER,
+#define IFLA_MASTER IFLA_MASTER
+ IFLA_WIRELESS, /* Wireless Extension event - see wireless.h */
+#define IFLA_WIRELESS IFLA_WIRELESS
+ IFLA_PROTINFO, /* Protocol specific information for a link */
+#define IFLA_PROTINFO IFLA_PROTINFO
+ IFLA_TXQLEN,
+#define IFLA_TXQLEN IFLA_TXQLEN
+ IFLA_MAP,
+#define IFLA_MAP IFLA_MAP
+ IFLA_WEIGHT,
+#define IFLA_WEIGHT IFLA_WEIGHT
+ IFLA_OPERSTATE,
+ IFLA_LINKMODE,
+ __IFLA_MAX
+};
+
+
+#define IFLA_MAX (__IFLA_MAX - 1)
+
+/* ifi_flags.
+
+ IFF_* flags.
+
+ The only change is:
+ IFF_LOOPBACK, IFF_BROADCAST and IFF_POINTOPOINT are
+ more not changeable by user. They describe link media
+ characteristics and set by device driver.
+
+ Comments:
+ - Combination IFF_BROADCAST|IFF_POINTOPOINT is invalid
+ - If neither of these three flags are set;
+ the interface is NBMA.
+
+ - IFF_MULTICAST does not mean anything special:
+ multicasts can be used on all not-NBMA links.
+ IFF_MULTICAST means that this media uses special encapsulation
+ for multicast frames. Apparently, all IFF_POINTOPOINT and
+ IFF_BROADCAST devices are able to use multicasts too.
+ */
+
+/* IFLA_LINK.
+ For usual devices it is equal ifi_index.
+ If it is a "virtual interface" (f.e. tunnel), ifi_link
+ can point to real physical interface (f.e. for bandwidth calculations),
+ or maybe 0, what means, that real media is unknown (usual
+ for IPIP tunnels, when route to endpoint is allowed to change)
+ */
+
+/* Subtype attributes for IFLA_PROTINFO */
+enum
+{
+ IFLA_INET6_UNSPEC,
+ IFLA_INET6_FLAGS, /* link flags */
+ IFLA_INET6_CONF, /* sysctl parameters */
+ IFLA_INET6_STATS, /* statistics */
+ IFLA_INET6_MCAST, /* MC things. What of them? */
+ IFLA_INET6_CACHEINFO, /* time values and max reasm size */
+ __IFLA_INET6_MAX
+};
+
+#define IFLA_INET6_MAX (__IFLA_INET6_MAX - 1)
+
+struct ifla_cacheinfo
+{
+ __u32 max_reasm_len;
+ __u32 tstamp; /* ipv6InterfaceTable updated timestamp */
+ __u32 reachable_time;
+ __u32 retrans_time;
+};
#endif /* _LINUX_IF_H */