[POWERPC] Fix swapper_pg_dir size when CONFIG_PTE_64BIT=y on FSL_BOOKE

[linux-2.6] / include / asm-powerpc / commproc.h

diff --git a/include/asm-powerpc/commproc.h b/include/asm-powerpc/commproc.h
index 397248705e0ed88060f7a76e1ef4adef617b34f1..a2328b8addd83b927fb0d0642f623fc4112d7ba6 100644 (file)
--- a/include/asm-powerpc/commproc.h
+++ b/include/asm-powerpc/commproc.h
@@ -19,6 +19,7 @@
 
 #include <asm/8xx_immap.h>
 #include <asm/ptrace.h>
+#include <asm/cpm.h>
 
 /* CPM Command register.
 */
@@ -54,6 +55,7 @@
 
 #define mk_cr_cmd(CH, CMD)     ((CMD << 8) | (CH << 4))
 
+#ifndef CONFIG_PPC_CPM_NEW_BINDING
 /* The dual ported RAM is multi-functional.  Some areas can be (and are
  * being) used for microcode.  There is an area that can only be used
  * as data ram for buffer descriptors, which is all we use right now.
@@ -62,24 +64,34 @@
 #define CPM_DATAONLY_BASE      ((uint)0x0800)
 #define CPM_DATAONLY_SIZE      ((uint)0x0700)
 #define CPM_DP_NOSPACE         ((uint)0x7fffffff)
+#endif
 
 /* Export the base address of the communication processor registers
  * and dual port ram.
  */
-extern cpm8xx_t        *cpmp;          /* Pointer to comm processor */
+extern cpm8xx_t __iomem *cpmp; /* Pointer to comm processor */
+
+#ifdef CONFIG_PPC_CPM_NEW_BINDING
+#define cpm_dpalloc cpm_muram_alloc
+#define cpm_dpfree cpm_muram_free
+#define cpm_dpram_addr cpm_muram_addr
+#define cpm_dpram_phys cpm_muram_dma
+#else
 extern unsigned long cpm_dpalloc(uint size, uint align);
 extern int cpm_dpfree(unsigned long offset);
 extern unsigned long cpm_dpalloc_fixed(unsigned long offset, uint size, uint align);
 extern void cpm_dpdump(void);
 extern void *cpm_dpram_addr(unsigned long offset);
 extern uint cpm_dpram_phys(u8* addr);
+#endif
+
 extern void cpm_setbrg(uint brg, uint rate);
 
 extern uint m8xx_cpm_hostalloc(uint size);
 extern int  m8xx_cpm_hostfree(uint start);
 extern void m8xx_cpm_hostdump(void);
 
-extern void cpm_load_patch(volatile immap_t *immr);
+extern void cpm_load_patch(cpm8xx_t *cp);
 
 /* Buffer descriptors used by many of the CPM protocols.
 */
@@ -689,4 +701,55 @@ typedef struct risc_timer_pram {
 extern void cpm_install_handler(int vec, void (*handler)(void *), void *dev_id);
 extern void cpm_free_handler(int vec);
 
+#define IMAP_ADDR              (get_immrbase())
+
+#define CPM_PIN_INPUT     0
+#define CPM_PIN_OUTPUT    1
+#define CPM_PIN_PRIMARY   0
+#define CPM_PIN_SECONDARY 2
+#define CPM_PIN_GPIO      4
+#define CPM_PIN_OPENDRAIN 8
+
+enum cpm_port {
+       CPM_PORTA,
+       CPM_PORTB,
+       CPM_PORTC,
+       CPM_PORTD,
+       CPM_PORTE,
+};
+
+void cpm1_set_pin(enum cpm_port port, int pin, int flags);
+
+enum cpm_clk_dir {
+       CPM_CLK_RX,
+       CPM_CLK_TX,
+       CPM_CLK_RTX
+};
+
+enum cpm_clk_target {
+       CPM_CLK_SCC1,
+       CPM_CLK_SCC2,
+       CPM_CLK_SCC3,
+       CPM_CLK_SCC4,
+       CPM_CLK_SMC1,
+       CPM_CLK_SMC2,
+};
+
+enum cpm_clk {
+       CPM_BRG1,       /* Baud Rate Generator  1 */
+       CPM_BRG2,       /* Baud Rate Generator  2 */
+       CPM_BRG3,       /* Baud Rate Generator  3 */
+       CPM_BRG4,       /* Baud Rate Generator  4 */
+       CPM_CLK1,       /* Clock  1 */
+       CPM_CLK2,       /* Clock  2 */
+       CPM_CLK3,       /* Clock  3 */
+       CPM_CLK4,       /* Clock  4 */
+       CPM_CLK5,       /* Clock  5 */
+       CPM_CLK6,       /* Clock  6 */
+       CPM_CLK7,       /* Clock  7 */
+       CPM_CLK8,       /* Clock  8 */
+};
+
+int cpm1_clk_setup(enum cpm_clk_target target, int clock, int mode);
+
 #endif /* __CPM_8XX__ */