#ifndef _OMAP_BOARD_H
#define _OMAP_BOARD_H
-#include <linux/config.h>
#include <linux/types.h>
/* Different peripheral ids */
#define OMAP_TAG_LCD 0x4f05
#define OMAP_TAG_GPIO_SWITCH 0x4f06
#define OMAP_TAG_UART 0x4f07
+#define OMAP_TAG_FBMEM 0x4f08
+#define OMAP_TAG_STI_CONSOLE 0x4f09
#define OMAP_TAG_BOOT_REASON 0x4f80
#define OMAP_TAG_FLASH_PART 0x4f81
+#define OMAP_TAG_VERSION_STR 0x4f82
struct omap_clock_config {
/* 0 for 12 MHz, 1 for 13 MHz and 2 for 19.2 MHz */
u8 system_clock_type;
};
+struct omap_mmc_conf {
+ unsigned enabled:1;
+ /* nomux means "standard" muxing is wrong on this board, and that
+ * board-specific code handled it before common init logic.
+ */
+ unsigned nomux:1;
+ /* switch pin can be for card detect (default) or card cover */
+ unsigned cover:1;
+ /* 4 wire signaling is optional, and is only used for SD/SDIO */
+ unsigned wire4:1;
+ s16 power_pin;
+ s16 switch_pin;
+ s16 wp_pin;
+};
+
struct omap_mmc_config {
- u8 mmc_blocks;
- s16 mmc1_power_pin, mmc2_power_pin;
- s16 mmc1_switch_pin, mmc2_switch_pin;
+ struct omap_mmc_conf mmc[2];
};
struct omap_serial_console_config {
u32 console_speed;
};
+struct omap_sti_console_config {
+ unsigned enable:1;
+ u8 channel;
+};
+
struct omap_usb_config {
/* Configure drivers according to the connectors on your board:
* - "A" connector (rectagular)
char ctrl_name[16];
};
+struct omap_fbmem_config {
+ u32 fb_sram_start;
+ u32 fb_sram_size;
+ u32 fb_sdram_start;
+ u32 fb_sdram_size;
+};
+
/* Cover:
* high -> closed
* low -> open
int key_code:24; /* Linux key code */
};
+struct omap_uart_config {
+ /* Bit field of UARTs present; bit 0 --> UART1 */
+ unsigned int enabled_uarts;
+};
+
+
struct omap_flash_part_config {
char part_table[0];
};
char reason_str[12];
};
-struct omap_uart_config {
- /* Bit field of UARTs present; bit 0 --> UART1 */
- unsigned int enabled_uarts;
+struct omap_version_config {
+ char component[12];
+ char version[12];
};
+
+#include <asm-arm/arch-omap/board-nokia.h>
+
struct omap_board_config_entry {
u16 tag;
u16 len;