The LTV350QV panel is present on all ATSTK1000 boards.
+config LCD_ILI9320
+ tristate
+ depends on LCD_CLASS_DEVICE && BACKLIGHT_LCD_SUPPORT
+ default n
+ help
+ If you have a panel based on the ILI9320 controller chip
+ then say y to include a power driver for it.
+
+config LCD_VGG2432A4
+ tristate "VGG2432A4 LCM device support"
+ depends on BACKLIGHT_LCD_SUPPORT && LCD_CLASS_DEVICE && SPI_MASTER
+ select LCD_ILI9320
+ default n
+ help
+ If you have a VGG2432A4 panel based on the ILI9320 controller chip
+ then say y to include a power driver for it.
+
#
# Backlight
#
To have support for your specific LCD panel you will have to
select the proper drivers which depend on this option.
+config BACKLIGHT_ATMEL_LCDC
+ bool "Atmel LCDC Contrast-as-Backlight control"
+ depends on BACKLIGHT_CLASS_DEVICE && FB_ATMEL
+ default y if MACH_SAM9261EK || MACH_SAM9263EK
+ help
+ This provides a backlight control internal to the Atmel LCDC
+ driver. If the LCD "contrast control" on your board is wired
+ so it controls the backlight brightness, select this option to
+ export this as a PWM-based backlight control.
+
+ If in doubt, it's safe to enable this option; it doesn't kick
+ in unless the board's description says it's wired that way.
+
config BACKLIGHT_CORGI
tristate "Generic (aka Sharp Corgi) Backlight Driver"
depends on BACKLIGHT_CLASS_DEVICE
If you have a Sharp Zaurus SL-5500 (Collie) or SL-5600 (Poodle) say y to
enable the LCD/backlight driver.
+config BACKLIGHT_OMAP1
+ tristate "OMAP1 PWL-based LCD Backlight"
+ depends on BACKLIGHT_CLASS_DEVICE && ARCH_OMAP1
+ default y
+ help
+ This driver controls the LCD backlight level and power for
+ the PWL module of OMAP1 processors. Say Y if your board
+ uses this hardware.
+
config BACKLIGHT_HP680
tristate "HP Jornada 680 Backlight Driver"
depends on BACKLIGHT_CLASS_DEVICE && SH_HP6XX
help
If you have a Intel LE80578 (Carillo Ranch) say Y to enable the
backlight driver.
+
+config BACKLIGHT_PWM
+ tristate "Generic PWM based Backlight Driver"
+ depends on BACKLIGHT_CLASS_DEVICE && HAVE_PWM
+ help
+ If you have a LCD backlight adjustable by PWM, say Y to enable
+ this driver.