This is the frame buffer device driver for the Amiga FrameMaster
card from BSC (exhibited 1992 but not shipped as a CBM product).
+config FB_ARC
+ tristate "Arc Monochrome LCD board support"
+ depends on FB && X86
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ select FB_SOFT_CURSOR
+ help
+ This enables support for the Arc Monochrome LCD board. The board
+ is based on the KS-108 lcd controller and is typically a matrix
+ of 2*n chips. This driver was tested with a 128x64 panel. This
+ driver supports it for use with x86 SBCs through a 16 bit GPIO
+ interface (8 bit data, 8 bit control). If you anticpate using
+ this driver, say Y or M; otherwise say N. You must specify the
+ GPIO IO address to be used for setting control and data.
+
config FB_ATARI
bool "Atari native chipset support"
depends on (FB = y) && ATARI && BROKEN
Say Y here to enable kernel support for the on-board framebuffer.
config FB_G364
- bool
- depends on MIPS_MAGNUM_4000 || OLIVETTI_M700
+ bool "G364 frame buffer support"
+ depends on (FB = y) && (MIPS_MAGNUM_4000 || OLIVETTI_M700)
select FB_CFB_FILLRECT
select FB_CFB_COPYAREA
select FB_CFB_IMAGEBLIT