#include <linux/dma-mapping.h>
#include <linux/spi/spi.h>
#include <linux/workqueue.h>
-#include <linux/errno.h>
#include <linux/delay.h>
#include <asm/io.h>
dev_dbg(&drv_data->pdev->dev, "in dma_irq_handler\n");
clear_dma_irqstat(CH_SPI);
+ /* Wait for DMA to complete */
+ while (get_dma_curr_irqstat(CH_SPI) & DMA_RUN)
+ continue;
+
/*
- * wait for the last transaction shifted out. yes, these two
- * while loops are supposed to be the same (see the HRM).
+ * wait for the last transaction shifted out. HRM states:
+ * at this point there may still be data in the SPI DMA FIFO waiting
+ * to be transmitted ... software needs to poll TXS in the SPI_STAT
+ * register until it goes low for 2 successive reads
*/
if (drv_data->tx != NULL) {
- while (bfin_read_SPI_STAT() & TXS)
- continue;
- while (bfin_read_SPI_STAT() & TXS)
+ while ((bfin_read_SPI_STAT() & TXS) ||
+ (bfin_read_SPI_STAT() & TXS))
continue;
}
return -ENODEV;
}
- dev_dbg(&spi->dev, "setup spi chip %s, width is %d, dma is %d,",
+ dev_dbg(&spi->dev, "setup spi chip %s, width is %d, dma is %d\n",
spi->modalias, chip->width, chip->enable_dma);
dev_dbg(&spi->dev, "ctl_reg is 0x%x, flag_reg is 0x%x\n",
chip->ctl_reg, chip->flag);
*/
static void cleanup(struct spi_device *spi)
{
- struct chip_data *chip = spi_get_ctldata((struct spi_device *)spi);
+ struct chip_data *chip = spi_get_ctldata(spi);
kfree(chip);
}
/* init messages workqueue */
INIT_WORK(&drv_data->pump_messages, pump_messages);
drv_data->workqueue =
- create_singlethread_workqueue(drv_data->master->cdev.dev->bus_id);
+ create_singlethread_workqueue(drv_data->master->dev.parent->bus_id);
if (drv_data->workqueue == NULL)
return -EBUSY;
#define bfin5xx_spi_resume NULL
#endif /* CONFIG_PM */
+MODULE_ALIAS("bfin-spi-master"); /* for platform bus hotplug */
static struct platform_driver bfin5xx_spi_driver = {
- .driver = {
+ .driver = {
.name = "bfin-spi-master",
.owner = THIS_MODULE,
},