* SuperH on-chip serial module support. (SCI with no FIFO / with FIFO)
*
* Copyright (C) 2002 - 2006 Paul Mundt
+ * Modified to support SH7720 SCIF. Markus Brunner, Mark Jonas (Jul 2007).
*
* based off of the old drivers/char/sh-sci.c by:
*
}
sci_out(port, SCFCR, fcr_val);
}
+#elif defined(CONFIG_CPU_SUBTYPE_SH7720)
+static void sci_init_pins_scif(struct uart_port *port, unsigned int cflag)
+{
+ unsigned int fcr_val = 0;
+ unsigned short data;
+
+ if (cflag & CRTSCTS) {
+ /* enable RTS/CTS */
+ if (port->mapbase == 0xa4430000) { /* SCIF0 */
+ /* Clear PTCR bit 9-2; enable all scif pins but sck */
+ data = ctrl_inw(PORT_PTCR);
+ ctrl_outw((data & 0xfc03), PORT_PTCR);
+ } else if (port->mapbase == 0xa4438000) { /* SCIF1 */
+ /* Clear PVCR bit 9-2 */
+ data = ctrl_inw(PORT_PVCR);
+ ctrl_outw((data & 0xfc03), PORT_PVCR);
+ }
+ fcr_val |= SCFCR_MCE;
+ } else {
+ if (port->mapbase == 0xa4430000) { /* SCIF0 */
+ /* Clear PTCR bit 5-2; enable only tx and rx */
+ data = ctrl_inw(PORT_PTCR);
+ ctrl_outw((data & 0xffc3), PORT_PTCR);
+ } else if (port->mapbase == 0xa4438000) { /* SCIF1 */
+ /* Clear PVCR bit 5-2 */
+ data = ctrl_inw(PORT_PVCR);
+ ctrl_outw((data & 0xffc3), PORT_PVCR);
+ }
+ }
+ sci_out(port, SCFCR, fcr_val);
+}
+
#elif defined(CONFIG_CPU_SH3)
/* For SH7705, SH7706, SH7707, SH7709, SH7709A, SH7729 */
static void sci_init_pins_scif(struct uart_port *port, unsigned int cflag)
console_initcall(sci_console_init);
#endif /* CONFIG_SERIAL_SH_SCI_CONSOLE */
-#ifdef CONFIG_SH_KGDB
+#ifdef CONFIG_SH_KGDB_CONSOLE
/*
* FIXME: Most of this can go away.. at the moment, we rely on
* arch/sh/kernel/setup.c to do the command line parsing for kgdb, though
return uart_set_options(port, co, baud, parity, bits, flow);
}
-#endif /* CONFIG_SH_KGDB */
-#ifdef CONFIG_SH_KGDB_CONSOLE
static struct console kgdb_console = {
.name = "ttySC",
.device = uart_console_device,
#ifdef CONFIG_CPU_FREQ
cpufreq_register_notifier(&sci_nb, CPUFREQ_TRANSITION_NOTIFIER);
- dev_info(&dev->dev, "sci: CPU frequency notifier registered\n");
+ dev_info(&dev->dev, "CPU frequency notifier registered\n");
#endif
#ifdef CONFIG_SH_STANDARD_BIOS