/*====================================================================*/
static int setup_serial(struct pcmcia_device *handle, struct serial_info * info,
- kio_addr_t iobase, int irq)
+ unsigned int iobase, int irq)
{
struct uart_port port;
int line;
static int simple_config(struct pcmcia_device *link)
{
- static const kio_addr_t base[5] = { 0x3f8, 0x2f8, 0x3e8, 0x2e8, 0x0 };
+ static const unsigned int base[5] = { 0x3f8, 0x2f8, 0x3e8, 0x2e8, 0x0 };
static const int size_table[2] = { 8, 16 };
struct serial_info *info = link->priv;
struct serial_cfg_mem *cfg_mem;
/* If the card is already configured, look up the port and irq */
i = pcmcia_get_configuration_info(link, &config);
if ((i == CS_SUCCESS) && (config.Attributes & CONF_VALID_CLIENT)) {
- kio_addr_t port = 0;
+ unsigned int port = 0;
if ((config.BasePort2 != 0) && (config.NumPorts2 == 8)) {
port = config.BasePort2;
info->slave = 1;