/*
* This routine sends a break character out the serial port.
*/
-static void send_break(ser_info_t *info, int duration)
+static void send_break(ser_info_t *info, unsigned int duration)
{
- set_current_state(TASK_INTERRUPTIBLE);
#ifdef SERIAL_DEBUG_SEND_BREAK
printk("rs_send_break(%d) jiff=%lu...", duration, jiffies);
#endif
begin_break(info);
- schedule_timeout(duration);
+ msleep_interruptible(duration);
end_break(info);
#ifdef SERIAL_DEBUG_SEND_BREAK
printk("done jiffies=%lu\n", jiffies);
if (signal_pending(current))
return -EINTR;
if (!arg) {
- send_break(info, HZ/4); /* 1/4 second */
+ send_break(info, 250); /* 1/4 second */
if (signal_pending(current))
return -EINTR;
}
tty_wait_until_sent(tty, 0);
if (signal_pending(current))
return -EINTR;
- send_break(info, arg ? arg*(HZ/10) : HZ/4);
+ send_break(info, arg ? arg*100 : 250);
if (signal_pending(current))
return -EINTR;
return 0;
.tiocmset = rs_360_tiocmset,
};
-/* int __init rs_360_init(void) */
-int rs_360_init(void)
+static int __init rs_360_init(void)
{
struct serial_state * state;
ser_info_t *info;
return 0;
}
-
-
-
-
+module_init(rs_360_init);
/* This must always be called before the rs_360_init() function, otherwise
* it blows away the port control information.