#include "sata_promise.h"
#define DRV_NAME "sata_sx4"
-#define DRV_VERSION "0.8"
+#define DRV_VERSION "0.9"
enum {
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.queuecommand = ata_scsi_queuecmd,
- .eh_strategy_handler = ata_scsi_error,
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = LIBATA_MAX_PRD,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
+ .slave_destroy = ata_scsi_slave_destroy,
.bios_param = ata_std_bios_param,
};
.phy_reset = pdc_20621_phy_reset,
.qc_prep = pdc20621_qc_prep,
.qc_issue = pdc20621_qc_issue_prot,
+ .data_xfer = ata_mmio_data_xfer,
.eng_timeout = pdc_eng_timeout,
.irq_handler = pdc20621_interrupt,
.irq_clear = pdc20621_irq_clear,
.sht = &pdc_sata_sht,
.host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY |
ATA_FLAG_SRST | ATA_FLAG_MMIO |
- ATA_FLAG_PIO_POLLING,
+ ATA_FLAG_NO_ATAPI | ATA_FLAG_PIO_POLLING,
.pio_mask = 0x1f, /* pio0-4 */
.mwdma_mask = 0x07, /* mwdma0-2 */
.udma_mask = 0x7f, /* udma0-6 ; FIXME */
switch (qc->tf.protocol) {
case ATA_PROT_DMA:
case ATA_PROT_NODATA:
- printk(KERN_ERR "ata%u: command timeout\n", ap->id);
+ ata_port_printk(ap, KERN_ERR, "command timeout\n");
qc->err_mask |= __ac_err_mask(ata_wait_idle(ap));
break;
default:
drv_stat = ata_busy_wait(ap, ATA_BUSY | ATA_DRQ, 1000);
- printk(KERN_ERR "ata%u: unknown timeout, cmd 0x%x stat 0x%x\n",
- ap->id, qc->tf.command, drv_stat);
+ ata_port_printk(ap, KERN_ERR,
+ "unknown timeout, cmd 0x%x stat 0x%x\n",
+ qc->tf.command, drv_stat);
qc->err_mask |= ac_err_mask(drv_stat);
break;
if (!printed_version++)
dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
- /*
- * If this driver happens to only be useful on Apple's K2, then
- * we should check that here as it has a normal Serverworks ID
- */
rc = pci_enable_device(pdev);
if (rc)
return rc;