#include <linux/delay.h>
#include <linux/interrupt.h>
#include <linux/dma-mapping.h>
+#include <linux/device.h>
#include <scsi/scsi_host.h>
-#include "scsi.h"
+#include <scsi/scsi_cmnd.h>
#include <linux/libata.h>
#include <asm/io.h>
PORT_CS_DEV_RST = (1 << 1), /* device reset */
PORT_CS_INIT = (1 << 2), /* port initialize */
PORT_CS_IRQ_WOC = (1 << 3), /* interrupt write one to clear */
+ PORT_CS_CDB16 = (1 << 5), /* 0=12b cdb, 1=16b cdb */
PORT_CS_RESUME = (1 << 6), /* port resume */
PORT_CS_32BIT_ACTV = (1 << 10), /* 32-bit activation */
PORT_CS_PM_EN = (1 << 13), /* port multiplier enable */
PORT_CERR_XFR_PCIPERR = 35, /* PSD ecode 11 - PCI prity err during transfer */
PORT_CERR_SENDSERVICE = 36, /* FIS received while sending service */
+ /* bits of PRB control field */
+ PRB_CTRL_PROTOCOL = (1 << 0), /* override def. ATA protocol */
+ PRB_CTRL_PACKET_READ = (1 << 4), /* PACKET cmd read */
+ PRB_CTRL_PACKET_WRITE = (1 << 5), /* PACKET cmd write */
+ PRB_CTRL_NIEN = (1 << 6), /* Mask completion irq */
+ PRB_CTRL_SRST = (1 << 7), /* Soft reset request (ign BSY?) */
+
+ /* PRB protocol field */
+ PRB_PROT_PACKET = (1 << 0),
+ PRB_PROT_TCQ = (1 << 1),
+ PRB_PROT_NCQ = (1 << 2),
+ PRB_PROT_READ = (1 << 3),
+ PRB_PROT_WRITE = (1 << 4),
+ PRB_PROT_TRANSPARENT = (1 << 5),
+
/*
* Other constants
*/
SGE_TRM = (1 << 31), /* Last SGE in chain */
- PRB_SOFT_RST = (1 << 7), /* Soft reset request (ign BSY?) */
+ SGE_LNK = (1 << 30), /* linked list
+ Points to SGT, not SGE */
+ SGE_DRD = (1 << 29), /* discard data read (/dev/null)
+ data address ignored */
/* board id */
BID_SIL3124 = 0,
};
static u8 sil24_check_status(struct ata_port *ap);
-static u8 sil24_check_err(struct ata_port *ap);
static u32 sil24_scr_read(struct ata_port *ap, unsigned sc_reg);
static void sil24_scr_write(struct ata_port *ap, unsigned sc_reg, u32 val);
static void sil24_tf_read(struct ata_port *ap, struct ata_taskfile *tf);
static void sil24_host_stop(struct ata_host_set *host_set);
static int sil24_init_one(struct pci_dev *pdev, const struct pci_device_id *ent);
-static struct pci_device_id sil24_pci_tbl[] = {
+static const struct pci_device_id sil24_pci_tbl[] = {
{ 0x1095, 0x3124, PCI_ANY_ID, PCI_ANY_ID, 0, 0, BID_SIL3124 },
{ 0x1095, 0x3132, PCI_ANY_ID, PCI_ANY_ID, 0, 0, BID_SIL3132 },
{ 0x1095, 0x3131, PCI_ANY_ID, PCI_ANY_ID, 0, 0, BID_SIL3131 },
.remove = ata_pci_remove_one, /* safe? */
};
-static Scsi_Host_Template sil24_sht = {
+static struct scsi_host_template sil24_sht = {
.module = THIS_MODULE,
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.check_status = sil24_check_status,
.check_altstatus = sil24_check_status,
- .check_err = sil24_check_err,
.dev_select = ata_noop_dev_select,
.tf_read = sil24_tf_read,
return pp->tf.command;
}
-static u8 sil24_check_err(struct ata_port *ap)
-{
- struct sil24_port_priv *pp = ap->private_data;
- return pp->tf.feature;
-}
-
static int sil24_scr_map[] = {
[SCR_CONTROL] = 0,
[SCR_STATUS] = 1,
qc = ata_qc_from_tag(ap, ap->active_tag);
if (!qc) {
- printk(KERN_ERR "ata%u: BUG: tiemout without command\n",
+ printk(KERN_ERR "ata%u: BUG: timeout without command\n",
ap->id);
return;
}
*/
printk(KERN_ERR "ata%u: command timeout\n", ap->id);
qc->scsidone = scsi_finish_command;
- ata_qc_complete(qc, ATA_ERR);
+ ata_qc_complete(qc, AC_ERR_OTHER);
sil24_reset_controller(ap);
}
struct sil24_port_priv *pp = ap->private_data;
void __iomem *port = (void __iomem *)ap->ioaddr.cmd_addr;
u32 irq_stat, cmd_err, sstatus, serror;
+ unsigned int err_mask;
irq_stat = readl(port + PORT_IRQ_STAT);
writel(irq_stat, port + PORT_IRQ_STAT); /* clear irq */
* Device is reporting error, tf registers are valid.
*/
sil24_update_tf(ap);
+ err_mask = ac_err_mask(pp->tf.command);
} else {
/*
* Other errors. libata currently doesn't have any
* mechanism to report these errors. Just turn on
* ATA_ERR.
*/
- pp->tf.command = ATA_ERR;
+ err_mask = AC_ERR_OTHER;
}
if (qc)
- ata_qc_complete(qc, pp->tf.command);
+ ata_qc_complete(qc, err_mask);
sil24_reset_controller(ap);
}
sil24_update_tf(ap);
if (qc)
- ata_qc_complete(qc, pp->tf.command);
+ ata_qc_complete(qc, ac_err_mask(pp->tf.command));
} else
sil24_error_intr(ap, slot_stat);
}
return IRQ_RETVAL(handled);
}
+static inline void sil24_cblk_free(struct sil24_port_priv *pp, struct device *dev)
+{
+ const size_t cb_size = sizeof(*pp->cmd_block);
+
+ dma_free_coherent(dev, cb_size, pp->cmd_block, pp->cmd_block_dma);
+}
+
static int sil24_port_start(struct ata_port *ap)
{
struct device *dev = ap->host_set->dev;
struct sil24_cmd_block *cb;
size_t cb_size = sizeof(*cb);
dma_addr_t cb_dma;
+ int rc = -ENOMEM;
- pp = kmalloc(sizeof(*pp), GFP_KERNEL);
+ pp = kzalloc(sizeof(*pp), GFP_KERNEL);
if (!pp)
- return -ENOMEM;
- memset(pp, 0, sizeof(*pp));
+ goto err_out;
pp->tf.command = ATA_DRDY;
cb = dma_alloc_coherent(dev, cb_size, &cb_dma, GFP_KERNEL);
- if (!cb) {
- kfree(pp);
- return -ENOMEM;
- }
+ if (!cb)
+ goto err_out_pp;
memset(cb, 0, cb_size);
+ rc = ata_pad_alloc(ap, dev);
+ if (rc)
+ goto err_out_pad;
+
pp->cmd_block = cb;
pp->cmd_block_dma = cb_dma;
ap->private_data = pp;
return 0;
+
+err_out_pad:
+ sil24_cblk_free(pp, dev);
+err_out_pp:
+ kfree(pp);
+err_out:
+ return rc;
}
static void sil24_port_stop(struct ata_port *ap)
{
struct device *dev = ap->host_set->dev;
struct sil24_port_priv *pp = ap->private_data;
- size_t cb_size = sizeof(*pp->cmd_block);
- dma_free_coherent(dev, cb_size, pp->cmd_block, pp->cmd_block_dma);
+ sil24_cblk_free(pp, dev);
+ ata_pad_free(ap, dev);
kfree(pp);
}
int i, rc;
if (!printed_version++)
- printk(KERN_DEBUG DRV_NAME " version " DRV_VERSION "\n");
+ dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
rc = pci_enable_device(pdev);
if (rc)
*/
rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME "(%s): 32-bit DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit DMA enable failed\n");
goto out_free;
}
rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME "(%s): 32-bit consistent DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit consistent DMA enable failed\n");
goto out_free;
}
break;
}
if (tmp & PORT_CS_PORT_RST)
- printk(KERN_ERR DRV_NAME
- "(%s): failed to clear port RST\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "failed to clear port RST\n");
}
/* Zero error counters. */
/* Reset itself */
if (__sil24_reset_controller(port))
- printk(KERN_ERR DRV_NAME
- "(%s): failed to reset controller\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "failed to reset controller\n");
}
/* Turn on interrupts */