PDC_RESET = (1 << 11), /* HDMA reset */
PDC_COMMON_FLAGS = ATA_FLAG_NO_LEGACY | ATA_FLAG_SRST |
- ATA_FLAG_MMIO | ATA_FLAG_NO_ATAPI,
+ ATA_FLAG_MMIO | ATA_FLAG_NO_ATAPI |
+ ATA_FLAG_PIO_POLLING,
};
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.queuecommand = ata_scsi_queuecmd,
- .eh_timed_out = ata_scsi_timed_out,
- .eh_strategy_handler = ata_scsi_error,
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = LIBATA_MAX_PRD,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
+ .slave_destroy = ata_scsi_slave_destroy,
.bios_param = ata_std_bios_param,
};
.qc_prep = pdc_qc_prep,
.qc_issue = pdc_qc_issue_prot,
.eng_timeout = pdc_eng_timeout,
+ .data_xfer = ata_mmio_data_xfer,
.irq_handler = pdc_interrupt,
.irq_clear = pdc_irq_clear,
.qc_prep = pdc_qc_prep,
.qc_issue = pdc_qc_issue_prot,
+ .data_xfer = ata_mmio_data_xfer,
.eng_timeout = pdc_eng_timeout,
.irq_handler = pdc_interrupt,
.irq_clear = pdc_irq_clear,
board_20319 },
{ PCI_VENDOR_ID_PROMISE, 0x3319, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
board_20319 },
+ { PCI_VENDOR_ID_PROMISE, 0x3515, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
+ board_20319 },
{ PCI_VENDOR_ID_PROMISE, 0x3519, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
board_20319 },
{ PCI_VENDOR_ID_PROMISE, 0x3d17, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
sata_phy_reset(ap);
}
-static void pdc_pata_phy_reset(struct ata_port *ap)
+static void pdc_pata_cbl_detect(struct ata_port *ap)
{
- /* FIXME: add cable detect. Don't assume 40-pin cable */
- ap->cbl = ATA_CBL_PATA40;
- ap->udma_mask &= ATA_UDMA_MASK_40C;
+ u8 tmp;
+ void __iomem *mmio = (void *) ap->ioaddr.cmd_addr + PDC_CTLSTAT + 0x03;
+
+ tmp = readb(mmio);
+
+ if (tmp & 0x01) {
+ ap->cbl = ATA_CBL_PATA40;
+ ap->udma_mask &= ATA_UDMA_MASK_40C;
+ } else
+ ap->cbl = ATA_CBL_PATA80;
+}
+static void pdc_pata_phy_reset(struct ata_port *ap)
+{
+ pdc_pata_cbl_detect(ap);
pdc_reset_port(ap);
ata_port_probe(ap);
ata_bus_reset(ap);
switch (qc->tf.protocol) {
case ATA_PROT_DMA:
case ATA_PROT_NODATA:
- printk(KERN_ERR "ata%u: command timeout\n", ap->id);
+ ata_port_printk(ap, KERN_ERR, "command timeout\n");
drv_stat = ata_wait_idle(ap);
qc->err_mask |= __ac_err_mask(drv_stat);
break;
default:
drv_stat = ata_busy_wait(ap, ATA_BUSY | ATA_DRQ, 1000);
- printk(KERN_ERR "ata%u: unknown timeout, cmd 0x%x stat 0x%x\n",
- ap->id, qc->tf.command, drv_stat);
+ ata_port_printk(ap, KERN_ERR,
+ "unknown timeout, cmd 0x%x stat 0x%x\n",
+ qc->tf.command, drv_stat);
qc->err_mask |= ac_err_mask(drv_stat);
break;
ap = host_set->ports[i];
tmp = mask & (1 << (i + 1));
if (tmp && ap &&
- !(ap->flags & (ATA_FLAG_PORT_DISABLED | ATA_FLAG_NOINTR))) {
+ !(ap->flags & ATA_FLAG_DISABLED)) {
struct ata_queued_cmd *qc;
qc = ata_qc_from_tag(ap, ap->active_tag);
- if (qc && (!(qc->tf.ctl & ATA_NIEN)))
+ if (qc && (!(qc->tf.flags & ATA_TFLAG_POLLING)))
handled += pdc_host_intr(ap, qc);
}
}
if (!printed_version++)
dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
- /*
- * If this driver happens to only be useful on Apple's K2, then
- * we should check that here as it has a normal Serverworks ID
- */
rc = pci_enable_device(pdev);
if (rc)
return rc;