else if (!strcmp (parm, "no"))
cio_show_msg = 0;
else
- printk (KERN_ERR "cio_setup : invalid cio_msg parameter '%s'",
- parm);
+ printk(KERN_ERR "cio: cio_setup: "
+ "invalid cio_msg parameter '%s'", parm);
return 1;
}
goto out_unregister;
debug_register_view (cio_debug_crw_id, &debug_sprintf_view);
debug_set_level (cio_debug_crw_id, 2);
- pr_debug("debugging initialized\n");
return 0;
out_unregister:
debug_unregister (cio_debug_trace_id);
if (cio_debug_crw_id)
debug_unregister (cio_debug_crw_id);
- pr_debug("could not initialize debugging\n");
+ printk(KERN_WARNING"cio: could not initialize debugging\n");
return -1;
}
*/
if (sch->st != 0) {
CIO_DEBUG(KERN_INFO, 0,
- "Subchannel 0.%x.%04x reports "
+ "cio: Subchannel 0.%x.%04x reports "
"non-I/O subchannel type %04X\n",
sch->schid.ssid, sch->schid.sch_no, sch->st);
/* We stop here for non-io subchannels. */
sch->lpm = sch->schib.pmcw.pam & sch->opm;
CIO_DEBUG(KERN_INFO, 0,
- "Detected device %04x on subchannel 0.%x.%04X"
+ "cio: Detected device %04x on subchannel 0.%x.%04X"
" - PIM = %02X, PAM = %02X, POM = %02X\n",
sch->schib.pmcw.dev, sch->schid.ssid,
sch->schid.sch_no, sch->schib.pmcw.pim,
/* unlike in 2.4, we cannot autoprobe here, since
* the channel subsystem is not fully initialized.
* With some luck, the HWC console can take over */
- printk(KERN_WARNING "No ccw console found!\n");
+ printk(KERN_WARNING "cio: No ccw console found!\n");
return -1;
}
return console_irq;