#define TI122X_SCR_SER_STEP 0xc0000000
#define TI122X_SCR_INTRTIE 0x20000000
+#define TIXX21_SCR_TIEALL 0x10000000
#define TI122X_SCR_CBRSVD 0x00400000
#define TI122X_SCR_MRBURSTDN 0x00008000
#define TI122X_SCR_MRBURSTUP 0x00004000
int devfn;
unsigned int state;
int ret = 1;
+ u32 sysctl;
/* catch the two-slot controllers */
switch (socket->dev->device) {
*/
break;
+ case PCI_DEVICE_ID_TI_X515:
+ case PCI_DEVICE_ID_TI_X420:
+ case PCI_DEVICE_ID_TI_X620:
+ case PCI_DEVICE_ID_TI_XX21_XX11:
+ case PCI_DEVICE_ID_TI_7410:
+ case PCI_DEVICE_ID_TI_7610:
+ /*
+ * those are either single or dual slot CB with additional functions
+ * like 1394, smartcard reader, etc. check the TIEALL flag for them
+ * the TIEALL flag binds the IRQ of all functions toghether.
+ * we catch the single slot variants later.
+ */
+ sysctl = config_readl(socket, TI113X_SYSTEM_CONTROL);
+ if (sysctl & TIXX21_SCR_TIEALL)
+ return 0;
+
+ break;
+
/* single-slot controllers have the 2nd slot empty always :) */
default:
return 1;
if (!func)
return 1;
+ /*
+ * check that the device id of both slots match. this is needed for the
+ * XX21 and the XX11 controller that share the same device id for single
+ * and dual slot controllers. return '2nd slot empty'. we already checked
+ * if the interrupt is tied to another function.
+ */
+ if (socket->dev->device != func->device)
+ goto out;
+
slot2 = pci_get_drvdata(func);
if (!slot2)
goto out;
* Some fixup code to make everybody happy (TM).
*/
+#ifdef CONFIG_CARDBUS
/**
* set/clear various test bits:
* Defaults to clear the bit.
config_writeb(socket, ENE_TEST_C9, test_c9);
}
-
static int ene_override(struct yenta_socket *socket)
{
/* install tune_bridge() function */
return ti1250_override(socket);
}
+#else
+# define ene_override ti1250_override
+#endif
#endif /* _LINUX_TI113X_H */