* use the PowerTweak utility (see http://powertweak.sourceforge.net).
*/
-#include <linux/config.h>
#include <linux/types.h>
#include <linux/kernel.h>
#include <linux/pci.h>
#include <linux/acpi.h>
#include "pci.h"
+/* The Mellanox Tavor device gives false positive parity errors
+ * Mark this device with a broken_parity_status, to allow
+ * PCI scanning code to "skip" this now blacklisted device.
+ */
+static void __devinit quirk_mellanox_tavor(struct pci_dev *dev)
+{
+ dev->broken_parity_status = 1; /* This device gives false positives */
+}
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_MELLANOX,PCI_DEVICE_ID_MELLANOX_TAVOR,quirk_mellanox_tavor);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_MELLANOX,PCI_DEVICE_ID_MELLANOX_TAVOR_BRIDGE,quirk_mellanox_tavor);
+
/* Deal with broken BIOS'es that neglect to enable passive release,
which can cause problems in combination with the 82441FX/PPro MTRRs */
static void __devinit quirk_passive_release(struct pci_dev *dev)
* non-x86 architectures (yes Via exists on PPC among other places),
* we must mask the PCI_INTERRUPT_LINE value versus 0xf to get
* interrupts delivered properly.
+ *
+ * Some of the on-chip devices are actually '586 devices' so they are
+ * listed here.
*/
static void quirk_via_irq(struct pci_dev *dev)
{
new_irq = dev->irq & 0xf;
pci_read_config_byte(dev, PCI_INTERRUPT_LINE, &irq);
if (new_irq != irq) {
- printk(KERN_INFO "PCI: Via IRQ fixup for %s, from %d to %d\n",
+ printk(KERN_INFO "PCI: VIA IRQ fixup for %s, from %d to %d\n",
pci_name(dev), irq, new_irq);
udelay(15); /* unknown if delay really needed */
pci_write_config_byte(dev, PCI_INTERRUPT_LINE, new_irq);
}
}
-DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_ANY_ID, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_0, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_1, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_2, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_3, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686_4, quirk_via_irq);
+DECLARE_PCI_FIXUP_ENABLE(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C686_5, quirk_via_irq);
/*
* VIA VT82C598 has its device ID settable and many BIOSes
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82375, quirk_eisa_bridge );
+/*
+ * On the MSI-K8T-Neo2Fir Board, the internal Soundcard is disabled
+ * when a PCI-Soundcard is added. The BIOS only gives Options
+ * "Disabled" and "AUTO". This Quirk Sets the corresponding
+ * Register-Value to enable the Soundcard.
+ *
+ * FIXME: Presently this quirk will run on anything that has an 8237
+ * which isn't correct, we need to check DMI tables or something in
+ * order to make sure it only runs on the MSI-K8T-Neo2Fir. Because it
+ * runs everywhere at present we suppress the printk output in most
+ * irrelevant cases.
+ */
+static void __init k8t_sound_hostbridge(struct pci_dev *dev)
+{
+ unsigned char val;
+
+ pci_read_config_byte(dev, 0x50, &val);
+ if (val == 0x88 || val == 0xc8) {
+ /* Assume it's probably a MSI-K8T-Neo2Fir */
+ printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, attempting to turn soundcard ON\n");
+ pci_write_config_byte(dev, 0x50, val & (~0x40));
+
+ /* Verify the Change for Status output */
+ pci_read_config_byte(dev, 0x50, &val);
+ if (val & 0x40)
+ printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, soundcard still off\n");
+ else
+ printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, soundcard on\n");
+ }
+}
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_8237, k8t_sound_hostbridge);
+
+#ifndef CONFIG_ACPI_SLEEP
/*
* On ASUS P4B boards, the SMBus PCI Device within the ICH2/4 southbridge
* is not activated. The myth is that Asus said that they do not want the
* bridge. Unfortunately, this device has no subvendor/subdevice ID. So it
* becomes necessary to do this tweak in two steps -- I've chosen the Host
* bridge as trigger.
+ *
+ * Actually, leaving it unhidden and not redoing the quirk over suspend2ram
+ * will cause thermal management to break down, and causing machine to
+ * overheat.
*/
-static int __initdata asus_hides_smbus = 0;
+static int __initdata asus_hides_smbus;
static void __init asus_hides_smbus_hostbridge(struct pci_dev *dev)
{
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_ICH6_1, asus_hides_smbus_lpc_ich6 );
+#endif
+
/*
* SiS 96x south bridge: BIOS typically hides SMBus device...
*/
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, 0x1460, quirk_p64h2_1k_io);
+/* Under some circumstances, AER is not linked with extended capabilities.
+ * Force it to be linked by setting the corresponding control bit in the
+ * config space.
+ */
+static void __devinit quirk_nvidia_ck804_pcie_aer_ext_cap(struct pci_dev *dev)
+{
+ uint8_t b;
+ if (pci_read_config_byte(dev, 0xf41, &b) == 0) {
+ if (!(b & 0x20)) {
+ pci_write_config_byte(dev, 0xf41, b | 0x20);
+ printk(KERN_INFO
+ "PCI: Linking AER extended capability on %s\n",
+ pci_name(dev));
+ }
+ }
+}
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_NVIDIA, PCI_DEVICE_ID_NVIDIA_CK804_PCIE,
+ quirk_nvidia_ck804_pcie_aer_ext_cap);
+
EXPORT_SYMBOL(pcie_mch_quirk);
#ifdef CONFIG_HOTPLUG
EXPORT_SYMBOL(pci_fixup_device);