/*
* Configuration handlers.
*/
-static void rt73usb_config_mac_addr(struct rt2x00_dev *rt2x00dev, __le32 *mac)
+static void rt73usb_config_intf(struct rt2x00_dev *rt2x00dev,
+ struct rt2x00_intf *intf,
+ struct rt2x00intf_conf *conf,
+ const unsigned int flags)
{
- u32 tmp;
-
- tmp = le32_to_cpu(mac[1]);
- rt2x00_set_field32(&tmp, MAC_CSR3_UNICAST_TO_ME_MASK, 0xff);
- mac[1] = cpu_to_le32(tmp);
-
- rt73usb_register_multiwrite(rt2x00dev, MAC_CSR2, mac,
- (2 * sizeof(__le32)));
-}
+ unsigned int beacon_base;
+ u32 reg;
-static void rt73usb_config_bssid(struct rt2x00_dev *rt2x00dev, __le32 *bssid)
-{
- u32 tmp;
+ if (flags & CONFIG_UPDATE_TYPE) {
+ /*
+ * Clear current synchronisation setup.
+ * For the Beacon base registers we only need to clear
+ * the first byte since that byte contains the VALID and OWNER
+ * bits which (when set to 0) will invalidate the entire beacon.
+ */
+ beacon_base = HW_BEACON_OFFSET(intf->beacon->entry_idx);
+ rt73usb_register_write(rt2x00dev, TXRX_CSR9, 0);
+ rt73usb_register_write(rt2x00dev, beacon_base, 0);
- tmp = le32_to_cpu(bssid[1]);
- rt2x00_set_field32(&tmp, MAC_CSR5_BSS_ID_MASK, 3);
- bssid[1] = cpu_to_le32(tmp);
+ /*
+ * Enable synchronisation.
+ */
+ rt73usb_register_read(rt2x00dev, TXRX_CSR9, ®);
+ rt2x00_set_field32(®, TXRX_CSR9_TSF_TICKING, 1);
+ rt2x00_set_field32(®, TXRX_CSR9_TBTT_ENABLE,
+ (conf->sync == TSF_SYNC_BEACON));
+ rt2x00_set_field32(®, TXRX_CSR9_BEACON_GEN, 0);
+ rt2x00_set_field32(®, TXRX_CSR9_TSF_SYNC, conf->sync);
+ rt73usb_register_write(rt2x00dev, TXRX_CSR9, reg);
+ }
- rt73usb_register_multiwrite(rt2x00dev, MAC_CSR4, bssid,
- (2 * sizeof(__le32)));
-}
+ if (flags & CONFIG_UPDATE_MAC) {
+ reg = le32_to_cpu(conf->mac[1]);
+ rt2x00_set_field32(®, MAC_CSR3_UNICAST_TO_ME_MASK, 0xff);
+ conf->mac[1] = cpu_to_le32(reg);
-static void rt73usb_config_type(struct rt2x00_dev *rt2x00dev, const int type,
- const int tsf_sync)
-{
- u32 reg;
+ rt73usb_register_multiwrite(rt2x00dev, MAC_CSR2,
+ conf->mac, sizeof(conf->mac));
+ }
- /*
- * Clear current synchronisation setup.
- * For the Beacon base registers we only need to clear
- * the first byte since that byte contains the VALID and OWNER
- * bits which (when set to 0) will invalidate the entire beacon.
- */
- rt73usb_register_write(rt2x00dev, TXRX_CSR9, 0);
- rt73usb_register_write(rt2x00dev, HW_BEACON_BASE0, 0);
- rt73usb_register_write(rt2x00dev, HW_BEACON_BASE1, 0);
- rt73usb_register_write(rt2x00dev, HW_BEACON_BASE2, 0);
- rt73usb_register_write(rt2x00dev, HW_BEACON_BASE3, 0);
+ if (flags & CONFIG_UPDATE_BSSID) {
+ reg = le32_to_cpu(conf->bssid[1]);
+ rt2x00_set_field32(®, MAC_CSR5_BSS_ID_MASK, 3);
+ conf->bssid[1] = cpu_to_le32(reg);
- /*
- * Enable synchronisation.
- */
- rt73usb_register_read(rt2x00dev, TXRX_CSR9, ®);
- rt2x00_set_field32(®, TXRX_CSR9_TSF_TICKING, 1);
- rt2x00_set_field32(®, TXRX_CSR9_TBTT_ENABLE,
- (tsf_sync == TSF_SYNC_BEACON));
- rt2x00_set_field32(®, TXRX_CSR9_BEACON_GEN, 0);
- rt2x00_set_field32(®, TXRX_CSR9_TSF_SYNC, tsf_sync);
- rt73usb_register_write(rt2x00dev, TXRX_CSR9, reg);
+ rt73usb_register_multiwrite(rt2x00dev, MAC_CSR4,
+ conf->bssid, sizeof(conf->bssid));
+ }
}
-static void rt73usb_config_preamble(struct rt2x00_dev *rt2x00dev,
- const int short_preamble,
- const int ack_timeout,
- const int ack_consume_time)
+static int rt73usb_config_preamble(struct rt2x00_dev *rt2x00dev,
+ const int short_preamble,
+ const int ack_timeout,
+ const int ack_consume_time)
{
u32 reg;
/*
- * When in atomic context, reschedule and let rt2x00lib
- * call this function again.
+ * When in atomic context, we should let rt2x00lib
+ * try this configuration again later.
*/
- if (in_atomic()) {
- queue_work(rt2x00dev->hw->workqueue, &rt2x00dev->config_work);
- return;
- }
+ if (in_atomic())
+ return -EAGAIN;
rt73usb_register_read(rt2x00dev, TXRX_CSR0, ®);
rt2x00_set_field32(®, TXRX_CSR0_RX_ACK_TIMEOUT, ack_timeout);
rt2x00_set_field32(®, TXRX_CSR4_AUTORESPOND_PREAMBLE,
!!short_preamble);
rt73usb_register_write(rt2x00dev, TXRX_CSR4, reg);
+
+ return 0;
}
static void rt73usb_config_phymode(struct rt2x00_dev *rt2x00dev,
}
static void rt73usb_config(struct rt2x00_dev *rt2x00dev,
- const unsigned int flags,
- struct rt2x00lib_conf *libconf)
+ struct rt2x00lib_conf *libconf,
+ const unsigned int flags)
{
if (flags & CONFIG_UPDATE_PHYMODE)
rt73usb_config_phymode(rt2x00dev, libconf->basic_rates);
}
}
+ /*
+ * If we are not associated, we should go straight to the
+ * dynamic CCA tuning.
+ */
+ if (!rt2x00dev->intf_associated)
+ goto dynamic_cca_tune;
+
/*
* Special big-R17 for very short distance
*/
return;
}
+dynamic_cca_tune:
+
/*
* r17 does not yet exceed upper limit, continue and base
* the r17 tuning on the false CCA count.
rt2x00_set_field32(®, MAC_CSR9_CW_SELECT, 0);
rt73usb_register_write(rt2x00dev, MAC_CSR9, reg);
+ /*
+ * Clear all beacons
+ * For the Beacon base registers we only need to clear
+ * the first byte since that byte contains the VALID and OWNER
+ * bits which (when set to 0) will invalidate the entire beacon.
+ */
+ rt73usb_register_write(rt2x00dev, HW_BEACON_BASE0, 0);
+ rt73usb_register_write(rt2x00dev, HW_BEACON_BASE1, 0);
+ rt73usb_register_write(rt2x00dev, HW_BEACON_BASE2, 0);
+ rt73usb_register_write(rt2x00dev, HW_BEACON_BASE3, 0);
+
/*
* We must clear the error counters.
* These registers are cleared on read,
rt2x00dev->hw->extra_tx_headroom = TXD_DESC_SIZE;
rt2x00dev->hw->max_signal = MAX_SIGNAL;
rt2x00dev->hw->max_rssi = MAX_RX_SSI;
- rt2x00dev->hw->queues = 5;
+ rt2x00dev->hw->queues = 4;
SET_IEEE80211_DEV(rt2x00dev->hw, &rt2x00dev_usb(rt2x00dev)->dev);
SET_IEEE80211_PERM_ADDR(rt2x00dev->hw,
rt73usb_probe_hw_mode(rt2x00dev);
/*
- * This device requires firmware
+ * This device requires firmware.
*/
__set_bit(DRIVER_REQUIRE_FIRMWARE, &rt2x00dev->flags);
+ __set_bit(DRIVER_REQUIRE_FIRMWARE_CRC_ITU_T, &rt2x00dev->flags);
/*
* Set the rssi offset.
}
static int rt73usb_beacon_update(struct ieee80211_hw *hw, struct sk_buff *skb,
- struct ieee80211_tx_control *control)
+ struct ieee80211_tx_control *control)
{
struct rt2x00_dev *rt2x00dev = hw->priv;
+ struct rt2x00_intf *intf = vif_to_intf(control->vif);
struct skb_frame_desc *skbdesc;
- struct data_queue *queue;
- struct queue_entry *entry;
- int timeout;
+ unsigned int beacon_base;
+ unsigned int timeout;
- /*
- * Just in case the ieee80211 doesn't set this,
- * but we need this queue set for the descriptor
- * initialization.
- */
- control->queue = IEEE80211_TX_QUEUE_BEACON;
- queue = rt2x00queue_get_queue(rt2x00dev, control->queue);
- entry = rt2x00queue_get_entry(queue, Q_INDEX);
+ if (unlikely(!intf->beacon))
+ return -ENOBUFS;
/*
* Add the descriptor in front of the skb.
*/
- skb_push(skb, queue->desc_size);
- memset(skb->data, 0, queue->desc_size);
+ skb_push(skb, intf->beacon->queue->desc_size);
+ memset(skb->data, 0, intf->beacon->queue->desc_size);
/*
* Fill in skb descriptor
*/
skbdesc = get_skb_frame_desc(skb);
memset(skbdesc, 0, sizeof(*skbdesc));
- skbdesc->data = skb->data + queue->desc_size;
- skbdesc->data_len = queue->data_size;
+ skbdesc->data = skb->data + intf->beacon->queue->desc_size;
+ skbdesc->data_len = skb->len - intf->beacon->queue->desc_size;
skbdesc->desc = skb->data;
- skbdesc->desc_len = queue->desc_size;
- skbdesc->entry = entry;
+ skbdesc->desc_len = intf->beacon->queue->desc_size;
+ skbdesc->entry = intf->beacon;
+ /*
+ * Just in case the ieee80211 doesn't set this,
+ * but we need this queue set for the descriptor
+ * initialization.
+ */
+ control->queue = IEEE80211_TX_QUEUE_BEACON;
rt2x00lib_write_tx_desc(rt2x00dev, skb, control);
/*
* Write entire beacon with descriptor to register,
* and kick the beacon generator.
*/
+ beacon_base = HW_BEACON_OFFSET(intf->beacon->entry_idx);
timeout = REGISTER_TIMEOUT * (skb->len / sizeof(u32));
rt2x00usb_vendor_request(rt2x00dev, USB_MULTI_WRITE,
- USB_VENDOR_REQUEST_OUT,
- HW_BEACON_BASE0, 0x0000,
+ USB_VENDOR_REQUEST_OUT, beacon_base, 0,
skb->data, skb->len, timeout);
- rt73usb_kick_tx_queue(rt2x00dev, IEEE80211_TX_QUEUE_BEACON);
+ rt73usb_kick_tx_queue(rt2x00dev, control->queue);
return 0;
}
.get_tx_data_len = rt73usb_get_tx_data_len,
.kick_tx_queue = rt73usb_kick_tx_queue,
.fill_rxdone = rt73usb_fill_rxdone,
- .config_mac_addr = rt73usb_config_mac_addr,
- .config_bssid = rt73usb_config_bssid,
- .config_type = rt73usb_config_type,
+ .config_intf = rt73usb_config_intf,
.config_preamble = rt73usb_config_preamble,
.config = rt73usb_config,
};
};
static const struct data_queue_desc rt73usb_queue_bcn = {
- .entry_num = BEACON_ENTRIES,
+ .entry_num = 4 * BEACON_ENTRIES,
.data_size = MGMT_FRAME_SIZE,
.desc_size = TXINFO_SIZE,
.priv_size = sizeof(struct queue_entry_priv_usb_tx),
static const struct rt2x00_ops rt73usb_ops = {
.name = KBUILD_MODNAME,
+ .max_sta_intf = 1,
+ .max_ap_intf = 4,
.eeprom_size = EEPROM_SIZE,
.rf_size = RF_SIZE,
.rx = &rt73usb_queue_rx,
projects / linux-2.6 / blobdiff