#define PFX KBUILD_MODNAME ": "
#define BCM43xx_SWITCH_CORE_MAX_RETRIES 50
-#define BCM43xx_IRQWAIT_MAX_RETRIES 50
+#define BCM43xx_IRQWAIT_MAX_RETRIES 100
#define BCM43xx_IO_SIZE 8192
/* Chipcommon registers. */
#define BCM43xx_CHIPCOMMON_CAPABILITIES 0x04
+#define BCM43xx_CHIPCOMMON_CTL 0x28
#define BCM43xx_CHIPCOMMON_PLLONDELAY 0xB0
#define BCM43xx_CHIPCOMMON_FREFSELDELAY 0xB4
#define BCM43xx_CHIPCOMMON_SLOWCLKCTL 0xB8
/* SBTOPCI2 values. */
#define BCM43xx_SBTOPCI2_PREFETCH 0x4
#define BCM43xx_SBTOPCI2_BURST 0x8
+#define BCM43xx_SBTOPCI2_MEMREAD_MULTI 0x20
+
+/* PCI-E core registers. */
+#define BCM43xx_PCIECORE_REG_ADDR 0x0130
+#define BCM43xx_PCIECORE_REG_DATA 0x0134
+#define BCM43xx_PCIECORE_MDIO_CTL 0x0128
+#define BCM43xx_PCIECORE_MDIO_DATA 0x012C
+
+/* PCI-E registers. */
+#define BCM43xx_PCIE_TLP_WORKAROUND 0x0004
+#define BCM43xx_PCIE_DLLP_LINKCTL 0x0100
+
+/* PCI-E MDIO bits. */
+#define BCM43xx_PCIE_MDIO_ST 0x40000000
+#define BCM43xx_PCIE_MDIO_WT 0x10000000
+#define BCM43xx_PCIE_MDIO_DEV 22
+#define BCM43xx_PCIE_MDIO_REG 18
+#define BCM43xx_PCIE_MDIO_TA 0x00020000
+#define BCM43xx_PCIE_MDIO_TC 0x0100
+
+/* MDIO devices. */
+#define BCM43xx_MDIO_SERDES_RX 0x1F
+
+/* SERDES RX registers. */
+#define BCM43xx_SERDES_RXTIMER 0x2
+#define BCM43xx_SERDES_CDR 0x6
+#define BCM43xx_SERDES_CDR_BW 0x7
/* Chipcommon capabilities. */
#define BCM43xx_CAPABILITIES_PCTL 0x00040000
#define BCM43xx_COREID_USB20_HOST 0x819
#define BCM43xx_COREID_USB20_DEV 0x81a
#define BCM43xx_COREID_SDIO_HOST 0x81b
+#define BCM43xx_COREID_PCIE 0x820
/* Core Information Registers */
#define BCM43xx_CIR_BASE 0xf00
#define BCM43xx_SBTMSTATELOW_REJECT 0x02
#define BCM43xx_SBTMSTATELOW_CLOCK 0x10000
#define BCM43xx_SBTMSTATELOW_FORCE_GATE_CLOCK 0x20000
+#define BCM43xx_SBTMSTATELOW_G_MODE_ENABLE 0x20000000
/* sbtmstatehigh state flags */
#define BCM43xx_SBTMSTATEHIGH_SERROR 0x00000001
#define BCM43xx_SBTMSTATEHIGH_BUSY 0x00000004
#define BCM43xx_SBTMSTATEHIGH_TIMEOUT 0x00000020
+#define BCM43xx_SBTMSTATEHIGH_G_PHY_AVAIL 0x00010000
+#define BCM43xx_SBTMSTATEHIGH_A_PHY_AVAIL 0x00020000
#define BCM43xx_SBTMSTATEHIGH_COREFLAGS 0x1FFF0000
#define BCM43xx_SBTMSTATEHIGH_DMA64BIT 0x10000000
#define BCM43xx_SBTMSTATEHIGH_GATEDCLK 0x20000000
#define BCM43xx_SBF_PS2 0x04000000
#define BCM43xx_SBF_NO_SSID_BCAST 0x08000000
#define BCM43xx_SBF_TIME_UPDATE 0x10000000
-#define BCM43xx_SBF_80000000 0x80000000 /*FIXME: fix name*/
+#define BCM43xx_SBF_MODE_G 0x80000000
+
+/* Microcode */
+#define BCM43xx_UCODE_REVISION 0x0000
+#define BCM43xx_UCODE_PATCHLEVEL 0x0002
+#define BCM43xx_UCODE_DATE 0x0004
+#define BCM43xx_UCODE_TIME 0x0006
+#define BCM43xx_UCODE_STATUS 0x0040
/* MicrocodeFlagsBitfield (addr + lo-word values?)*/
#define BCM43xx_UCODEFLAGS_OFFSET 0x005E
#define BCM43xx_UCODEFLAG_UNKPACTRL 0x0040
#define BCM43xx_UCODEFLAG_JAPAN 0x0080
+/* Hardware Radio Enable masks */
+#define BCM43xx_MMIO_RADIO_HWENABLED_HI_MASK (1 << 16)
+#define BCM43xx_MMIO_RADIO_HWENABLED_LO_MASK (1 << 4)
+
/* Generic-Interrupt reasons. */
#define BCM43xx_IRQ_READY (1 << 0)
#define BCM43xx_IRQ_BEACON (1 << 1)
#define BCM43xx_DEFAULT_SHORT_RETRY_LIMIT 7
#define BCM43xx_DEFAULT_LONG_RETRY_LIMIT 4
+/* FIXME: the next line is a guess as to what the maximum RSSI value might be */
+#define RX_RSSI_MAX 60
+
/* Max size of a security key */
#define BCM43xx_SEC_KEYSIZE 16
/* Security algorithms. */
u8 et1macaddr[6];
u8 et0phyaddr:5;
u8 et1phyaddr:5;
- u8 et0mdcport:1;
- u8 et1mdcport:1;
u8 boardrev;
u8 locale:4;
u8 antennas_aphy:2;
struct bcm43xx_phyinfo {
/* Hardware Data */
- u8 version;
+ u8 analog;
u8 type;
u8 rev;
u16 antenna_diversity;
#define BCM43xx_MAX_80211_CORES 2
-#ifdef CONFIG_BCM947XX
-#define core_offset(bcm) (bcm)->current_core_offset
-#else
-#define core_offset(bcm) 0
-#endif
-
/* Generic information about a core. */
struct bcm43xx_coreinfo {
u8 available:1,
};
struct bcm43xx_stats {
- u8 link_quality;
u8 noise;
struct iw_statistics wstats;
/* Store the last TX/RX times here for updating the leds. */
bad_frames_preempt:1, /* Use "Bad Frames Preemption" (default off) */
reg124_set_0x4:1, /* Some variable to keep track of IRQ stuff. */
short_preamble:1, /* TRUE, if short preamble is enabled. */
- firmware_norelease:1; /* Do not release the firmware. Used on suspend. */
+ firmware_norelease:1, /* Do not release the firmware. Used on suspend. */
+ radio_hw_enable:1; /* TRUE if radio is hardware enabled */
struct bcm43xx_stats stats;
* This is currently always BCM43xx_BUSTYPE_PCI
*/
u8 bustype;
+ u64 dma_mask;
u16 board_vendor;
u16 board_type;
/* The currently active core. */
struct bcm43xx_coreinfo *current_core;
-#ifdef CONFIG_BCM947XX
- /** current core memory offset */
- u32 current_core_offset;
-#endif
struct bcm43xx_coreinfo *active_80211_core;
/* coreinfo structs for all possible cores follow.
* Note that a core might not exist.
struct tasklet_struct isr_tasklet;
/* Periodic tasks */
- struct work_struct periodic_work;
+ struct delayed_work periodic_work;
unsigned int periodic_state;
struct work_struct restart_work;
static inline
u16 bcm43xx_read16(struct bcm43xx_private *bcm, u16 offset)
{
- return ioread16(bcm->mmio_addr + core_offset(bcm) + offset);
+ return ioread16(bcm->mmio_addr + offset);
}
static inline
void bcm43xx_write16(struct bcm43xx_private *bcm, u16 offset, u16 value)
{
- iowrite16(value, bcm->mmio_addr + core_offset(bcm) + offset);
+ iowrite16(value, bcm->mmio_addr + offset);
}
static inline
u32 bcm43xx_read32(struct bcm43xx_private *bcm, u16 offset)
{
- return ioread32(bcm->mmio_addr + core_offset(bcm) + offset);
+ return ioread32(bcm->mmio_addr + offset);
}
static inline
void bcm43xx_write32(struct bcm43xx_private *bcm, u16 offset, u32 value)
{
- iowrite32(value, bcm->mmio_addr + core_offset(bcm) + offset);
+ iowrite32(value, bcm->mmio_addr + offset);
}
static inline
projects / linux-2.6 / blobdiff