#include <linux/version.h>
#include <linux/module.h>
#include <linux/delay.h>
+#include <linux/hardirq.h>
#include <linux/if.h>
+#include <linux/io.h>
#include <linux/netdevice.h>
#include <linux/cache.h>
#include <linux/pci.h>
{ PCI_VDEVICE(ATHEROS, 0x001a), .driver_data = AR5K_AR5212 }, /* 2413 Griffin-lite */
{ PCI_VDEVICE(ATHEROS, 0x001b), .driver_data = AR5K_AR5212 }, /* 5413 Eagle */
{ PCI_VDEVICE(ATHEROS, 0x001c), .driver_data = AR5K_AR5212 }, /* 5424 Condor (PCI-E)*/
- { PCI_VDEVICE(ATHEROS, 0x0023), .driver_data = AR5K_AR5212 }, /* 5416 */
- { PCI_VDEVICE(ATHEROS, 0x0024), .driver_data = AR5K_AR5212 }, /* 5418 */
{ 0 }
};
MODULE_DEVICE_TABLE(pci, ath5k_pci_id_table);
/* Set private data */
pci_set_drvdata(pdev, hw);
- /* Enable msi for devices that support it */
- pci_enable_msi(pdev);
-
/* Setup interrupt handler */
ret = request_irq(pdev->irq, ath5k_intr, IRQF_SHARED, "ath", sc);
if (ret) {
err_irq:
free_irq(pdev->irq, sc);
err_free:
- pci_disable_msi(pdev);
ieee80211_free_hw(hw);
err_map:
pci_iounmap(pdev, mem);
ath5k_detach(pdev, hw);
ath5k_hw_detach(sc->ah);
free_irq(pdev->irq, sc);
- pci_disable_msi(pdev);
pci_iounmap(pdev, sc->iobase);
pci_release_region(pdev, 0);
pci_disable_device(pdev);
ath5k_led_off(sc);
ath5k_stop_hw(sc);
+
+ free_irq(pdev->irq, sc);
+ pci_disable_msi(pdev);
pci_save_state(pdev);
pci_disable_device(pdev);
pci_set_power_state(pdev, PCI_D3hot);
struct ath5k_hw *ah = sc->ah;
int i, err;
- err = pci_set_power_state(pdev, PCI_D0);
- if (err)
- return err;
+ pci_restore_state(pdev);
err = pci_enable_device(pdev);
if (err)
return err;
- pci_restore_state(pdev);
/*
* Suspend/Resume resets the PCI configuration space, so we have to
* re-disable the RETRY_TIMEOUT register (0x41) to keep
*/
pci_write_config_byte(pdev, 0x41, 0);
- ath5k_init(sc);
+ pci_enable_msi(pdev);
+
+ err = request_irq(pdev->irq, ath5k_intr, IRQF_SHARED, "ath", sc);
+ if (err) {
+ ATH5K_ERR(sc, "request_irq failed\n");
+ goto err_msi;
+ }
+
+ err = ath5k_init(sc);
+ if (err)
+ goto err_irq;
ath5k_led_enable(sc);
/*
ath5k_hw_reset_key(ah, i);
return 0;
+err_irq:
+ free_irq(pdev->irq, sc);
+err_msi:
+ pci_disable_msi(pdev);
+ pci_disable_device(pdev);
+ return err;
}
#endif /* CONFIG_PM */
pktlen = skb->len;
- if (!(info->flags & IEEE80211_TX_CTL_DO_NOT_ENCRYPT)) {
+ if (info->control.hw_key) {
keyidx = info->control.hw_key->hw_key_idx;
pktlen += info->control.icv_len;
}
txq->link = &ds->ds_link;
ath5k_hw_tx_start(ah, txq->qnum);
+ mmiowb();
spin_unlock_bh(&txq->lock);
return 0;
ath5k_hw_stop_pcu_recv(ah); /* disable PCU */
ath5k_hw_set_rx_filter(ah, 0); /* clear recv filter */
ath5k_hw_stop_rx_dma(ah); /* disable DMA engine */
- mdelay(3); /* 3ms is long enough for 1 frame */
ath5k_debug_printrxbuffs(sc, ah);
struct ath5k_rx_status rs = {};
struct sk_buff *skb;
struct ath5k_softc *sc = (void *)data;
- struct ath5k_buf *bf;
+ struct ath5k_buf *bf, *bf_last;
struct ath5k_desc *ds;
int ret;
int hdrlen;
int pad;
spin_lock(&sc->rxbuflock);
+ if (list_empty(&sc->rxbuf)) {
+ ATH5K_WARN(sc, "empty rx buf pool\n");
+ goto unlock;
+ }
+ bf_last = list_entry(sc->rxbuf.prev, struct ath5k_buf, list);
do {
rxs.flag = 0;
- if (unlikely(list_empty(&sc->rxbuf))) {
- ATH5K_WARN(sc, "empty rx buf pool\n");
- break;
- }
bf = list_first_entry(&sc->rxbuf, struct ath5k_buf, list);
BUG_ON(bf->skb == NULL);
skb = bf->skb;
ds = bf->desc;
- /* TODO only one segment */
- pci_dma_sync_single_for_cpu(sc->pdev, sc->desc_daddr,
- sc->desc_len, PCI_DMA_FROMDEVICE);
-
- if (unlikely(ds->ds_link == bf->daddr)) /* this is the end */
- break;
+ /*
+ * last buffer must not be freed to ensure proper hardware
+ * function. When the hardware finishes also a packet next to
+ * it, we are sure, it doesn't use it anymore and we can go on.
+ */
+ if (bf_last == bf)
+ bf->flags |= 1;
+ if (bf->flags) {
+ struct ath5k_buf *bf_next = list_entry(bf->list.next,
+ struct ath5k_buf, list);
+ ret = sc->ah->ah_proc_rx_desc(sc->ah, bf_next->desc,
+ &rs);
+ if (ret)
+ break;
+ bf->flags &= ~1;
+ /* skip the overwritten one (even status is martian) */
+ goto next;
+ }
ret = sc->ah->ah_proc_rx_desc(sc->ah, ds, &rs);
if (unlikely(ret == -EINPROGRESS))
goto next;
}
accept:
- pci_dma_sync_single_for_cpu(sc->pdev, bf->skbaddr,
- rs.rs_datalen, PCI_DMA_FROMDEVICE);
pci_unmap_single(sc->pdev, bf->skbaddr, sc->rxbufsize,
PCI_DMA_FROMDEVICE);
bf->skb = NULL;
next:
list_move_tail(&bf->list, &sc->rxbuf);
} while (ath5k_rxbuf_setup(sc, bf) == 0);
+unlock:
spin_unlock(&sc->rxbuflock);
}
list_for_each_entry_safe(bf, bf0, &txq->q, list) {
ds = bf->desc;
- /* TODO only one segment */
- pci_dma_sync_single_for_cpu(sc->pdev, sc->desc_daddr,
- sc->desc_len, PCI_DMA_FROMDEVICE);
ret = sc->ah->ah_proc_tx_desc(sc->ah, ds, &ts);
if (unlikely(ret == -EINPROGRESS))
break;
ATH5K_WARN(sc, "beacon queue %u didn't stop?\n", sc->bhalq);
/* NB: hw still stops DMA, so proceed */
}
- pci_dma_sync_single_for_cpu(sc->pdev, bf->skbaddr, bf->skb->len,
- PCI_DMA_TODEVICE);
ath5k_hw_put_tx_buf(ah, sc->bhalq, bf->daddr);
ath5k_hw_tx_start(ah, sc->bhalq);
ath5k_hw_set_intr(ah, 0);
sc->bmisscount = 0;
+ sc->imask &= ~(AR5K_INT_BMISS | AR5K_INT_SWBA);
if (sc->opmode == IEEE80211_IF_TYPE_STA) {
sc->imask |= AR5K_INT_BMISS;
ret = 0;
done:
+ mmiowb();
mutex_unlock(&sc->lock);
return ret;
}
if (!test_bit(ATH_STAT_INVALID, sc->status)) {
ath5k_led_off(sc);
ath5k_hw_set_intr(ah, 0);
+ synchronize_irq(sc->pdev->irq);
}
ath5k_txq_cleanup(sc);
if (!test_bit(ATH_STAT_INVALID, sc->status)) {
}
}
ath5k_txbuf_free(sc, sc->bbuf);
+ mmiowb();
mutex_unlock(&sc->lock);
del_timer_sync(&sc->calib_tim);
+ tasklet_kill(&sc->rxtq);
+ tasklet_kill(&sc->txtq);
+ tasklet_kill(&sc->restq);
return ret;
}
struct pci_dev *pdev = sc->pdev;
char name[ATH5K_LED_MAX_NAME_LEN + 1];
- sc->led_on = 0; /* active low */
-
/*
* Auto-enable soft led processing for IBM cards and for
* 5211 minipci cards.
pdev->device == PCI_DEVICE_ID_ATHEROS_AR5211) {
__set_bit(ATH_STAT_LEDSOFT, sc->status);
sc->led_pin = 0;
+ sc->led_on = 0; /* active low */
}
/* Enable softled on PIN1 on HP Compaq nc6xx, nc4000 & nx5000 laptops */
if (pdev->subsystem_vendor == PCI_VENDOR_ID_COMPAQ) {
__set_bit(ATH_STAT_LEDSOFT, sc->status);
sc->led_pin = 1;
+ sc->led_on = 1; /* active high */
}
if (!test_bit(ATH_STAT_LEDSOFT, sc->status))
goto out;
/* XXX: assoc id is set to 0 for now, mac80211 doesn't have
* a clean way of letting us retrieve this yet. */
ath5k_hw_set_associd(ah, ah->ah_bssid, 0);
+ mmiowb();
}
if (conf->changed & IEEE80211_IFCC_BEACON &&
}
unlock:
+ mmiowb();
mutex_unlock(&sc->lock);
return ret;
}
ath5k_debug_dump_skb(sc, skb, "BC ", 1);
- mutex_lock(&sc->lock);
-
if (sc->opmode != IEEE80211_IF_TYPE_IBSS) {
ret = -EIO;
goto end;
ret = ath5k_beacon_setup(sc, sc->bbuf);
if (ret)
sc->bbuf->skb = NULL;
- else
+ else {
ath5k_beacon_config(sc);
+ mmiowb();
+ }
end:
- mutex_unlock(&sc->lock);
return ret;
}
projects / linux-2.6 / blobdiff