======================================================================*/
-#include <linux/config.h>
#ifdef __IN_PCMCIA_PACKAGE__
#include <pcmcia/k_compat.h>
#endif
}
p_dev->priv = local;
- p_dev->state |= DEV_PRESENT | DEV_CONFIG_PENDING;
return airo_config(p_dev);
} /* airo_attach */
{
DEBUG(0, "airo_detach(0x%p)\n", link);
- if (link->state & DEV_CONFIG)
- airo_release(link);
+ airo_release(link);
if ( ((local_info_t*)link->priv)->eth_dev ) {
stop_airo_card( ((local_info_t*)link->priv)->eth_dev, 0 );
dev = link->priv;
DEBUG(0, "airo_config(0x%p)\n", link);
-
- /*
- This reads the card's CONFIG tuple to find its configuration
- registers.
- */
- tuple.DesiredTuple = CISTPL_CONFIG;
- tuple.Attributes = 0;
- tuple.TupleData = buf;
- tuple.TupleDataMax = sizeof(buf);
- tuple.TupleOffset = 0;
- CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
- CS_CHECK(GetTupleData, pcmcia_get_tuple_data(link, &tuple));
- CS_CHECK(ParseTuple, pcmcia_parse_tuple(link, &tuple, &parse));
- link->conf.ConfigBase = parse.config.base;
- link->conf.Present = parse.config.rmask[0];
-
- /* Configure card */
- link->state |= DEV_CONFIG;
-
+
/*
In this loop, we scan the CIS for configuration table entries,
each of which describes a valid card configuration, including
these things without consulting the CIS, and most client drivers
will only use the CIS to fill in implementation-defined details.
*/
+ tuple.Attributes = 0;
+ tuple.TupleData = buf;
+ tuple.TupleDataMax = sizeof(buf);
+ tuple.TupleOffset = 0;
tuple.DesiredTuple = CISTPL_CFTABLE_ENTRY;
CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
while (1) {
printk(", mem 0x%06lx-0x%06lx", req.Base,
req.Base+req.Size-1);
printk("\n");
-
- link->state &= ~DEV_CONFIG_PENDING;
return 0;
cs_failed:
{
local_info_t *local = link->priv;
- if (link->state & DEV_CONFIG)
- netif_device_detach(local->eth_dev);
+ netif_device_detach(local->eth_dev);
return 0;
}
{
local_info_t *local = link->priv;
- if ((link->state & DEV_CONFIG) && (link->open)) {
+ if (link->open) {
reset_airo_card(local->eth_dev);
netif_device_attach(local->eth_dev);
}