#include <linux/ioport.h>
#include <linux/eisa.h>
#include <linux/pci.h>
+#include <linux/dma-mapping.h>
#include <linux/netdevice.h>
#include <linux/etherdevice.h>
#include <linux/delay.h>
u16 device_id;
int reg, rc = -ENODEV;
+#ifdef CONFIG_PCI
if (pdev) {
rc = pci_enable_device(pdev);
if (rc)
goto err_out;
}
}
+#endif /* CONFIG_PCI */
dev = alloc_etherdev(sizeof(TLanPrivateInfo));
if (dev == NULL) {
priv->adapter = &board_info[ent->driver_data];
- rc = pci_set_dma_mask(pdev, 0xFFFFFFFF);
+ rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
printk(KERN_ERR "TLAN: No suitable PCI mapping available.\n");
goto err_out_free_dev;
int err;
priv->tlanRev = TLan_DioRead8( dev->base_addr, TLAN_DEF_REVISION );
- err = request_irq( dev->irq, TLan_HandleInterrupt, SA_SHIRQ, TLanSignature, dev );
+ err = request_irq( dev->irq, TLan_HandleInterrupt, IRQF_SHARED, TLanSignature, dev );
if ( err ) {
printk(KERN_ERR "TLAN: Cannot open %s because IRQ %d is already in use.\n", dev->name, dev->irq );
* for this device.
* phy The address of the PHY to be queried.
* reg The register whose contents are to be
- * retreived.
+ * retrieved.
* val A pointer to a variable to store the
* retrieved value.
*
- * This function uses the TLAN's MII bus to retreive the contents
+ * This function uses the TLAN's MII bus to retrieve the contents
* of a given register on a PHY. It sends the appropriate info
* and then reads the 16-bit register value from the MII bus via
* the TLAN SIO register.