#define HOSTCC_STATUS_ERROR_ATTN 0x00000004
#define HOSTCC_RXCOL_TICKS 0x00003c08
#define LOW_RXCOL_TICKS 0x00000032
+#define LOW_RXCOL_TICKS_CLRTCKS 0x00000014
#define DEFAULT_RXCOL_TICKS 0x00000048
#define HIGH_RXCOL_TICKS 0x00000096
#define HOSTCC_TXCOL_TICKS 0x00003c0c
#define LOW_TXCOL_TICKS 0x00000096
+#define LOW_TXCOL_TICKS_CLRTCKS 0x00000048
#define DEFAULT_TXCOL_TICKS 0x0000012c
#define HIGH_TXCOL_TICKS 0x00000145
#define HOSTCC_RXMAX_FRAMES 0x00003c10
#define HIGH_TXMAX_FRAMES 0x00000052
#define HOSTCC_RXCOAL_TICK_INT 0x00003c18
#define DEFAULT_RXCOAL_TICK_INT 0x00000019
+#define DEFAULT_RXCOAL_TICK_INT_CLRTCKS 0x00000014
#define HOSTCC_TXCOAL_TICK_INT 0x00003c1c
#define DEFAULT_TXCOAL_TICK_INT 0x00000019
+#define DEFAULT_TXCOAL_TICK_INT_CLRTCKS 0x00000014
#define HOSTCC_RXCOAL_MAXF_INT 0x00003c20
#define DEFAULT_RXCOAL_MAXF_INT 0x00000005
#define HOSTCC_TXCOAL_MAXF_INT 0x00003c24
#define GRC_LCLCTRL_CLEARINT 0x00000002
#define GRC_LCLCTRL_SETINT 0x00000004
#define GRC_LCLCTRL_INT_ON_ATTN 0x00000008
+#define GRC_LCLCTRL_GPIO_INPUT3 0x00000020
+#define GRC_LCLCTRL_GPIO_OE3 0x00000040
+#define GRC_LCLCTRL_GPIO_OUTPUT3 0x00000080
#define GRC_LCLCTRL_GPIO_INPUT0 0x00000100
#define GRC_LCLCTRL_GPIO_INPUT1 0x00000200
#define GRC_LCLCTRL_GPIO_INPUT2 0x00000400
#define FLASH_VENDOR_SAIFUN 0x01000003
#define FLASH_VENDOR_SST_SMALL 0x00000001
#define FLASH_VENDOR_SST_LARGE 0x02000001
+#define NVRAM_CFG1_5752VENDOR_MASK 0x03c00003
+#define FLASH_5752VENDOR_ATMEL_EEPROM_64KHZ 0x00000000
+#define FLASH_5752VENDOR_ATMEL_EEPROM_376KHZ 0x02000000
+#define FLASH_5752VENDOR_ATMEL_FLASH_BUFFERED 0x02000003
+#define FLASH_5752VENDOR_ST_M45PE10 0x02400000
+#define FLASH_5752VENDOR_ST_M45PE20 0x02400002
+#define FLASH_5752VENDOR_ST_M45PE40 0x02400001
+#define NVRAM_CFG1_5752PAGE_SIZE_MASK 0x70000000
+#define FLASH_5752PAGE_SIZE_256 0x00000000
+#define FLASH_5752PAGE_SIZE_512 0x10000000
+#define FLASH_5752PAGE_SIZE_1K 0x20000000
+#define FLASH_5752PAGE_SIZE_2K 0x30000000
+#define FLASH_5752PAGE_SIZE_4K 0x40000000
+#define FLASH_5752PAGE_SIZE_264 0x50000000
#define NVRAM_CFG2 0x00007018
#define NVRAM_CFG3 0x0000701c
#define NVRAM_SWARB 0x00007020
struct tg3 {
/* begin "general, frequently-used members" cacheline section */
+ /* If the IRQ handler (which runs lockless) needs to be
+ * quiesced, the following bitmask state is used. The
+ * SYNC flag is set by non-IRQ context code to initiate
+ * the quiescence.
+ *
+ * When the IRQ handler notices that SYNC is set, it
+ * disables interrupts and returns.
+ *
+ * When all outstanding IRQ handlers have returned after
+ * the SYNC flag has been set, the setter can be assured
+ * that interrupts will no longer get run.
+ *
+ * In this way all SMP driver locks are never acquired
+ * in hw IRQ context, only sw IRQ context or lower.
+ */
+ unsigned int irq_sync;
+
/* SMP locking strategy:
*
* lock: Held during all operations except TX packet
* processing.
*
- * tx_lock: Held during tg3_start_xmit{,_4gbug} and tg3_tx
+ * tx_lock: Held during tg3_start_xmit and tg3_tx
*
- * If you want to shut up all asynchronous processing you must
- * acquire both locks, 'lock' taken before 'tx_lock'. IRQs must
- * be disabled to take 'lock' but only softirq disabling is
- * necessary for acquisition of 'tx_lock'.
+ * Both of these locks are to be held with BH safety.
*/
spinlock_t lock;
spinlock_t indirect_lock;
struct tg3_hw_status *hw_status;
dma_addr_t status_mapping;
+ u32 last_tag;
u32 msg_enable;
u32 rx_offset;
u32 tg3_flags;
+#define TG3_FLAG_TAGGED_STATUS 0x00000001
#define TG3_FLAG_TXD_MBOX_HWBUG 0x00000002
#define TG3_FLAG_RX_CHECKSUMS 0x00000004
#define TG3_FLAG_USE_LINKCHG_REG 0x00000008
#define TG3_FLG2_SERDES_PREEMPHASIS 0x00020000
#define TG3_FLG2_5705_PLUS 0x00040000
#define TG3_FLG2_5750_PLUS 0x00080000
+#define TG3_FLG2_PROTECTED_NVRAM 0x00100000
+#define TG3_FLG2_USING_MSI 0x00200000
u32 split_mode_max_reqs;
#define SPLIT_MODE_5704_MAX_REQ 3
#define SST_25VF0X0_PAGE_SIZE 4098
-
+ struct ethtool_coalesce coal;
};
#endif /* !(_T3_H) */