#define CHIPREV_ID_5714_A2 0x9002
#define CHIPREV_ID_5906_A1 0xc001
#define CHIPREV_ID_5784_A0 0x5784000
+#define CHIPREV_ID_5784_A1 0x5784001
+#define CHIPREV_ID_5761_A0 0x5761000
+#define CHIPREV_ID_5761_A1 0x5761001
#define GET_ASIC_REV(CHIP_REV_ID) ((CHIP_REV_ID) >> 12)
#define ASIC_REV_5700 0x07
#define ASIC_REV_5701 0x00
#define SG_DIG_FIBER_MODE 0x00008000
#define SG_DIG_REMOTE_FAULT_MASK 0x00006000
#define SG_DIG_PAUSE_MASK 0x00001800
+#define SG_DIG_PAUSE_CAP 0x00000800
+#define SG_DIG_ASYM_PAUSE 0x00001000
#define SG_DIG_GBIC_ENABLE 0x00000400
#define SG_DIG_CHECK_END_ENABLE 0x00000200
#define SG_DIG_SGMII_AUTONEG_TIMER 0x00000100
#define SG_DIG_AUTONEG_LOW_ENABLE 0x00000004
#define SG_DIG_REMOTE_LOOPBACK 0x00000002
#define SG_DIG_LOOPBACK 0x00000001
+#define SG_DIG_COMMON_SETUP (SG_DIG_CRC16_CLEAR_N | \
+ SG_DIG_LOCAL_DUPLEX_STATUS | \
+ SG_DIG_LOCAL_LINK_STATUS | \
+ (0x2 << SG_DIG_SPEED_STATUS_SHIFT) | \
+ SG_DIG_FIBER_MODE | SG_DIG_GBIC_ENABLE)
#define SG_DIG_STATUS 0x000005b4
#define SG_DIG_CRC16_BUS_MASK 0xffff0000
#define SG_DIG_PARTNER_FAULT_MASK 0x00600000 /* If !MRADV_CRC16_SELECT */
#define CPMU_CTRL_LINK_IDLE_MODE 0x00000200
#define CPMU_CTRL_LINK_AWARE_MODE 0x00000400
#define CPMU_CTRL_LINK_SPEED_MODE 0x00004000
-/* 0x3604 --> 0x365c unused */
+#define TG3_CPMU_LSPD_10MB_CLK 0x00003604
+#define CPMU_LSPD_10MB_MACCLK_MASK 0x001f0000
+#define CPMU_LSPD_10MB_MACCLK_6_25 0x00130000
+/* 0x3608 --> 0x360c unused */
+
+#define TG3_CPMU_LSPD_1000MB_CLK 0x0000360c
+#define CPMU_LSPD_1000MB_MACCLK_62_5 0x00000000
+#define CPMU_LSPD_1000MB_MACCLK_12_5 0x00110000
+#define CPMU_LSPD_1000MB_MACCLK_MASK 0x001f0000
+#define TG3_CPMU_LNK_AWARE_PWRMD 0x00003610
+#define CPMU_LNK_AWARE_MACCLK_MASK 0x001f0000
+#define CPMU_LNK_AWARE_MACCLK_6_25 0x00130000
+/* 0x3614 --> 0x361c unused */
+
+#define TG3_CPMU_HST_ACC 0x0000361c
+#define CPMU_HST_ACC_MACCLK_MASK 0x001f0000
+#define CPMU_HST_ACC_MACCLK_6_25 0x00130000
+/* 0x3620 --> 0x3630 unused */
+
+#define TG3_CPMU_CLCK_STAT 0x00003630
+#define CPMU_CLCK_STAT_MAC_CLCK_MASK 0x001f0000
+#define CPMU_CLCK_STAT_MAC_CLCK_62_5 0x00000000
+#define CPMU_CLCK_STAT_MAC_CLCK_12_5 0x00110000
+#define CPMU_CLCK_STAT_MAC_CLCK_6_25 0x00130000
+/* 0x3634 --> 0x365c unused */
#define TG3_CPMU_MUTEX_REQ 0x0000365c
#define CPMU_MUTEX_REQ_DRIVER 0x00001000
#define TG3_EEPROM_MAGIC 0x669955aa
#define TG3_EEPROM_MAGIC_FW 0xa5000000
#define TG3_EEPROM_MAGIC_FW_MSK 0xff000000
+#define TG3_EEPROM_SB_FORMAT_MASK 0x00e00000
+#define TG3_EEPROM_SB_FORMAT_1 0x00200000
+#define TG3_EEPROM_SB_REVISION_MASK 0x001f0000
+#define TG3_EEPROM_SB_REVISION_0 0x00000000
+#define TG3_EEPROM_SB_REVISION_2 0x00020000
+#define TG3_EEPROM_SB_REVISION_3 0x00030000
#define TG3_EEPROM_MAGIC_HW 0xabcd
#define TG3_EEPROM_MAGIC_HW_MSK 0xffff
+#define TG3_NVM_DIR_START 0x18
+#define TG3_NVM_DIR_END 0x78
+#define TG3_NVM_DIRENT_SIZE 0xc
+#define TG3_NVM_DIRTYPE_SHIFT 24
+#define TG3_NVM_DIRTYPE_ASFINI 1
+
/* 32K Window into NIC internal memory */
#define NIC_SRAM_WIN_BASE 0x00008000
#define MII_TG3_ISTAT 0x1a /* IRQ status register */
#define MII_TG3_IMASK 0x1b /* IRQ mask register */
+#define MII_TG3_MISC_SHDW 0x1c
+#define MII_TG3_MISC_SHDW_WREN 0x8000
+#define MII_TG3_MISC_SHDW_APD_SEL 0x2800
+
+#define MII_TG3_MISC_SHDW_APD_WKTM_84MS 0x0001
+
/* ISTAT/IMASK event bits */
#define MII_TG3_INT_LINKCHG 0x0002
#define MII_TG3_INT_SPEEDCHG 0x0004
/* APE convenience enumerations. */
#define TG3_APE_LOCK_MEM 4
+#define TG3_EEPROM_SB_F1R2_MBA_OFF 0x10
+
/* There are two ways to manage the TX descriptors on the tigon3.
* Either the descriptors are in host DMA'able memory, or they
u16 speed;
u8 duplex;
u8 autoneg;
+ u8 flowctrl;
+#define TG3_FLOW_CTRL_TX 0x01
+#define TG3_FLOW_CTRL_RX 0x02
/* Describes what we actually have. */
- u16 active_speed;
+ u8 active_flowctrl;
+
u8 active_duplex;
#define SPEED_INVALID 0xffff
#define DUPLEX_INVALID 0xff
#define AUTONEG_INVALID 0xff
+ u16 active_speed;
/* When we go in and out of low power mode we need
* to swap with this state.
#define TG3_FLAG_EEPROM_WRITE_PROT 0x00001000
#define TG3_FLAG_NVRAM 0x00002000
#define TG3_FLAG_NVRAM_BUFFERED 0x00004000
-#define TG3_FLAG_RX_PAUSE 0x00008000
-#define TG3_FLAG_TX_PAUSE 0x00010000
#define TG3_FLAG_PCIX_MODE 0x00020000
#define TG3_FLAG_PCI_HIGH_SPEED 0x00040000
#define TG3_FLAG_PCI_32BIT 0x00080000
u32 tg3_flags3;
#define TG3_FLG3_NO_NVRAM_ADDR_TRANS 0x00000001
#define TG3_FLG3_ENABLE_APE 0x00000002
+#define TG3_FLG3_5761_5784_AX_FIXES 0x00000004
struct timer_list timer;
u16 timer_counter;
#define PHY_REV_BCM5411_X0 0x1 /* Found on Netgear GA302T */
u32 led_ctrl;
- u32 pci_cmd;
+ u16 pci_cmd;
char board_part_number[24];
- char fw_ver[16];
+#define TG3_VER_SIZE 32
+ char fw_ver[TG3_VER_SIZE];
u32 nic_sram_data_cfg;
u32 pci_clock_ctrl;
struct pci_dev *pdev_peer;