link->conf.Attributes = CONF_ENABLE_IRQ;
link->conf.IntType = INT_MEMORY_AND_IO;
link->conf.ConfigIndex = 1;
- link->conf.Present = PRESENT_OPTION;
/* The EL3-specific entries in the device structure. */
dev->hard_start_xmit = &el3_start_xmit;
struct net_device *dev = link->priv;
struct el3_private *lp = netdev_priv(dev);
tuple_t tuple;
- cisparse_t parse;
unsigned short buf[32];
int last_fn, last_ret, i, j;
kio_addr_t ioaddr;
DEBUG(0, "3c574_config(0x%p)\n", link);
- tuple.Attributes = 0;
- tuple.DesiredTuple = CISTPL_CONFIG;
- CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
- tuple.TupleData = (cisdata_t *)buf;
- tuple.TupleDataMax = 64;
- tuple.TupleOffset = 0;
- CS_CHECK(GetTupleData, pcmcia_get_tuple_data(link, &tuple));
- CS_CHECK(ParseTuple, pcmcia_parse_tuple(link, &tuple, &parse));
- link->conf.ConfigBase = parse.config.base;
- link->conf.Present = parse.config.rmask[0];
-
link->io.IOAddrLines = 16;
for (i = j = 0; j < 0x400; j += 0x20) {
link->io.BasePort1 = j ^ 0x300;
/* The 3c574 normally uses an EEPROM for configuration info, including
the hardware address. The future products may include a modem chip
and put the address in the CIS. */
+ tuple.Attributes = 0;
+ tuple.TupleData = (cisdata_t *)buf;
+ tuple.TupleDataMax = 64;
+ tuple.TupleOffset = 0;
tuple.DesiredTuple = 0x88;
if (pcmcia_get_first_tuple(link, &tuple) == CS_SUCCESS) {
pcmcia_get_tuple_data(link, &tuple);
if ((inw(ioaddr + EL3_STATUS) & IntLatch) && (inb(ioaddr + Timer) == 0xff)) {
if (!lp->fast_poll)
printk(KERN_INFO "%s: interrupt(s) dropped!\n", dev->name);
- el3_interrupt(dev->irq, lp);
+ el3_interrupt(dev->irq, dev);
lp->fast_poll = HZ;
}
if (lp->fast_poll) {
DEBUG(3, " Receiving packet size %d status %4.4x.\n",
pkt_len, rx_status);
if (skb != NULL) {
- skb->dev = dev;
skb_reserve(skb, 2);
insl(ioaddr+RX_FIFO, skb_put(skb, pkt_len),
((pkt_len+3)>>2));