#include <linux/delay.h>
#include <linux/netdevice.h>
#include <linux/etherdevice.h>
+#include <linux/jiffies.h>
#include <asm/system.h>
#include <asm/io.h>
+#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+#include <asm/tx4938/rbtx4938.h>
+#endif
+
#include "8390.h"
#define DRV_NAME "ne"
{"E-LAN100", "E-LAN200", {0x00, 0x00, 0x5d}}, /* Broken ne1000 clones */
{"PCM-4823", "PCM-4823", {0x00, 0xc0, 0x6c}}, /* Broken Advantech MoBo */
{"REALTEK", "RTL8019", {0x00, 0x00, 0xe8}}, /* no-name with Realtek chip */
+#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+ {"RBHMA4X00-RTL8019", "RBHMA4X00/RTL8019", {0x00, 0x60, 0x0a}}, /* Toshiba built-in */
+#endif
{"LCS-8834", "LCS-8836", {0x04, 0x04, 0x37}}, /* ShinyNet (SET) */
{NULL,}
};
#define NESM_START_PG 0x40 /* First page of TX buffer */
#define NESM_STOP_PG 0x80 /* Last page +1 of RX ring */
-#ifdef CONFIG_PLAT_MAPPI
+#if defined(CONFIG_PLAT_MAPPI)
# define DCR_VAL 0x4b
-#elif CONFIG_PLAT_OAKS32R
+#elif defined(CONFIG_PLAT_OAKS32R)
# define DCR_VAL 0x48
#else
# define DCR_VAL 0x49
return -ENODEV;
}
-static void cleanup_card(struct net_device *dev)
-{
- struct pnp_dev *idev = (struct pnp_dev *)ei_status.priv;
- if (idev)
- pnp_device_detach(idev);
- free_irq(dev->irq, dev);
- release_region(dev->base_addr, NE_IO_EXTENT);
-}
-
#ifndef MODULE
struct net_device * __init ne_probe(int unit)
{
sprintf(dev->name, "eth%d", unit);
netdev_boot_setup_check(dev);
+#ifdef CONFIG_TOSHIBA_RBTX4938
+ dev->base_addr = 0x07f20280;
+ dev->irq = RBTX4938_RTL_8019_IRQ;
+#endif
err = do_ne_probe(dev);
if (err)
goto out;
outb(inb(ioaddr + NE_RESET), ioaddr + NE_RESET);
while ((inb_p(ioaddr + EN0_ISR) & ENISR_RESET) == 0)
- if (jiffies - reset_start_time > 2*HZ/100) {
+ if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
if (bad_card) {
printk(" (warning: no reset ack)");
break;
ei_status.name = name;
ei_status.tx_start_page = start_page;
ei_status.stop_page = stop_page;
+#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+ wordlength = 1;
+#endif
+
#ifdef CONFIG_PLAT_OAKS32R
ei_status.word16 = 0;
#else
/* This check _should_not_ be necessary, omit eventually. */
while ((inb_p(NE_BASE+EN0_ISR) & ENISR_RESET) == 0)
- if (jiffies - reset_start_time > 2*HZ/100) {
+ if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
printk(KERN_WARNING "%s: ne_reset_8390() did not complete.\n", dev->name);
break;
}
#endif
while ((inb_p(nic_base + EN0_ISR) & ENISR_RDC) == 0)
- if (jiffies - dma_start > 2*HZ/100) { /* 20ms */
+ if (time_after(jiffies, dma_start + 2*HZ/100)) { /* 20ms */
printk(KERN_WARNING "%s: timeout waiting for Tx RDC.\n", dev->name);
ne_reset_8390(dev);
NS8390_init(dev,1);
return -ENODEV;
}
+static void cleanup_card(struct net_device *dev)
+{
+ struct pnp_dev *idev = (struct pnp_dev *)ei_status.priv;
+ if (idev)
+ pnp_device_detach(idev);
+ free_irq(dev->irq, dev);
+ release_region(dev->base_addr, NE_IO_EXTENT);
+}
+
void cleanup_module(void)
{
int this_dev;