static unsigned char lance_need_isa_bounce_buffers = 1;
static int lance_open(struct net_device *dev);
-static void lance_init_ring(struct net_device *dev, int mode);
+static void lance_init_ring(struct net_device *dev, gfp_t mode);
static int lance_start_xmit(struct sk_buff *skb, struct net_device *dev);
static int lance_rx(struct net_device *dev);
static irqreturn_t lance_interrupt(int irq, void *dev_id, struct pt_regs *regs);
\f
-static void cleanup_card(struct net_device *dev)
-{
- struct lance_private *lp = dev->priv;
- if (dev->dma != 4)
- free_dma(dev->dma);
- release_region(dev->base_addr, LANCE_TOTAL_SIZE);
- kfree(lp->tx_bounce_buffs);
- kfree((void*)lp->rx_buffs);
- kfree(lp);
-}
-
#ifdef MODULE
#define MAX_CARDS 8 /* Max number of interfaces (cards) per module */
return -ENXIO;
}
+static void cleanup_card(struct net_device *dev)
+{
+ struct lance_private *lp = dev->priv;
+ if (dev->dma != 4)
+ free_dma(dev->dma);
+ release_region(dev->base_addr, LANCE_TOTAL_SIZE);
+ kfree(lp->tx_bounce_buffs);
+ kfree((void*)lp->rx_buffs);
+ kfree(lp);
+}
+
void cleanup_module(void)
{
int this_dev;
static int did_version; /* Already printed version info. */
unsigned long flags;
int err = -ENOMEM;
+ void __iomem *bios;
/* First we look for special cases.
Check for HP's on-board ethernet by looking for 'HP' in the BIOS.
There are two HP versions, check the BIOS for the configuration port.
This method provided by L. Julliard, Laurent_Julliard@grenoble.hp.com.
*/
- if (isa_readw(0x000f0102) == 0x5048) {
+ bios = ioremap(0xf00f0, 0x14);
+ if (!bios)
+ return -ENOMEM;
+ if (readw(bios + 0x12) == 0x5048) {
static const short ioaddr_table[] = { 0x300, 0x320, 0x340, 0x360};
- int hp_port = (isa_readl(0x000f00f1) & 1) ? 0x499 : 0x99;
+ int hp_port = (readl(bios + 1) & 1) ? 0x499 : 0x99;
/* We can have boards other than the built-in! Verify this is on-board. */
if ((inb(hp_port) & 0xc0) == 0x80
&& ioaddr_table[inb(hp_port) & 3] == ioaddr)
hp_builtin = hp_port;
}
+ iounmap(bios);
/* We also recognize the HP Vectra on-board here, but check below. */
hpJ2405A = (inb(ioaddr) == 0x08 && inb(ioaddr+1) == 0x00
&& inb(ioaddr+2) == 0x09);
/* Initialize the LANCE Rx and Tx rings. */
static void
-lance_init_ring(struct net_device *dev, int gfp)
+lance_init_ring(struct net_device *dev, gfp_t gfp)
{
struct lance_private *lp = dev->priv;
int i;