ALSA: wm8750: add missing VREF output

[linux-2.6] / drivers / net / igb / igb_main.c

diff --git a/drivers/net/igb/igb_main.c b/drivers/net/igb/igb_main.c
index b602c4dd0d14697eef9fa10ee90c7080c853d269..8f66e15ec8d6299ed3f95272ff7ec24acde43c60 100644 (file)
--- a/drivers/net/igb/igb_main.c
+++ b/drivers/net/igb/igb_main.c
@@ -311,7 +311,7 @@ static void igb_assign_vector(struct igb_adapter *adapter, int rx_queue,
                array_wr32(E1000_MSIXBM(0), msix_vector, msixbm);
                break;
        case e1000_82576:
-               /* Kawela uses a table-based method for assigning vectors.
+               /* The 82576 uses a table-based method for assigning vectors.
                   Each queue has a single entry in the table to which we write
                   a vector number along with a "valid" bit.  Sadly, the layout
                   of the table is somewhat counterintuitive. */
@@ -720,28 +720,6 @@ static void igb_get_hw_control(struct igb_adapter *adapter)
                        ctrl_ext | E1000_CTRL_EXT_DRV_LOAD);
 }
 
-static void igb_init_manageability(struct igb_adapter *adapter)
-{
-       struct e1000_hw *hw = &adapter->hw;
-
-       if (adapter->en_mng_pt) {
-               u32 manc2h = rd32(E1000_MANC2H);
-               u32 manc = rd32(E1000_MANC);
-
-               /* enable receiving management packets to the host */
-               /* this will probably generate destination unreachable messages
-                * from the host OS, but the packets will be handled on SMBUS */
-               manc |= E1000_MANC_EN_MNG2HOST;
-#define E1000_MNG2HOST_PORT_623 (1 << 5)
-#define E1000_MNG2HOST_PORT_664 (1 << 6)
-               manc2h |= E1000_MNG2HOST_PORT_623;
-               manc2h |= E1000_MNG2HOST_PORT_664;
-               wr32(E1000_MANC2H, manc2h);
-
-               wr32(E1000_MANC, manc);
-       }
-}
-
 /**
  * igb_configure - configure the hardware for RX and TX
  * @adapter: private board structure
@@ -755,7 +733,6 @@ static void igb_configure(struct igb_adapter *adapter)
        igb_set_multi(netdev);
 
        igb_restore_vlan(adapter);
-       igb_init_manageability(adapter);
 
        igb_configure_tx(adapter);
        igb_setup_rctl(adapter);
@@ -1372,7 +1349,8 @@ static void __devexit igb_remove(struct pci_dev *pdev)
 
        unregister_netdev(netdev);
 
-       if (!igb_check_reset_block(&adapter->hw))
+       if (adapter->hw.phy.ops.reset_phy &&
+           !igb_check_reset_block(&adapter->hw))
                adapter->hw.phy.ops.reset_phy(&adapter->hw);
 
        igb_remove_device(&adapter->hw);
@@ -4523,8 +4501,6 @@ static void igb_io_resume(struct pci_dev *pdev)
        struct net_device *netdev = pci_get_drvdata(pdev);
        struct igb_adapter *adapter = netdev_priv(netdev);
 
-       igb_init_manageability(adapter);
-
        if (netif_running(netdev)) {
                if (igb_up(adapter)) {
                        dev_err(&pdev->dev, "igb_up failed after reset\n");