/* D-Link DL2000-based Gigabit Ethernet Adapter Linux driver */
-/*
+/*
Copyright (c) 2001, 2002 by D-Link Corporation
Written by Edward Peng.<edward_peng@dlink.com.tw>
Created 03-May-2001, base on Linux' sundance.c.
enum ASICCtrl_LoWord_bits {
PhyMedia = 0x0080,
};
-
+
enum ASICCtrl_HiWord_bits {
GlobalReset = 0x0001,
RxReset = 0x0002,
} ANLPAR_PCS_t, *PANLPAR_PCS_t;
enum _pcs_anlpar {
- PCS_ANLPAR_NEXT_PAGE = PCS_ANAR_NEXT_PAGE,
+ PCS_ANLPAR_NEXT_PAGE = PCS_ANAR_NEXT_PAGE,
PCS_ANLPAR_REMOTE_FAULT = PCS_ANAR_REMOTE_FAULT,
PCS_ANLPAR_ASYMMETRIC = PCS_ANAR_ASYMMETRIC,
PCS_ANLPAR_PAUSE = PCS_ANAR_PAUSE,
unsigned int rx_flow:1; /* Rx flow control enable */
unsigned int phy_media:1; /* 1: fiber, 0: copper */
unsigned int link_status:1; /* Current link status */
- unsigned char pci_rev_id; /* PCI revision ID */
struct netdev_desc *last_tx; /* Last Tx descriptor used. */
unsigned long cur_rx, old_rx; /* Producer/consumer ring indices */
unsigned long cur_tx, old_tx;
};
/* The station address location in the EEPROM. */
-#ifdef MEM_MAPPING
-#define PCI_IOTYPE (PCI_USES_MASTER | PCI_USES_MEM | PCI_ADDR1)
-#else
-#define PCI_IOTYPE (PCI_USES_MASTER | PCI_USES_IO | PCI_ADDR0)
-#endif
/* The struct pci_device_id consist of:
vendor, device Vendor and device ID to match (or PCI_ANY_ID)
subvendor, subdevice Subsystem vendor and device ID to match (or PCI_ANY_ID)
class_mask of the class are honored during the comparison.
driver_data Data private to the driver.
*/
-static struct pci_device_id rio_pci_tbl[] = {
- {0x1186, 0x4000, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
- {0,}
+
+static const struct pci_device_id rio_pci_tbl[] = {
+ {0x1186, 0x4000, PCI_ANY_ID, PCI_ANY_ID, },
+ { }
};
MODULE_DEVICE_TABLE (pci, rio_pci_tbl);
#define TX_TIMEOUT (4*HZ)