/* bnx2x.h: Broadcom Everest network driver.
*
- * Copyright (c) 2007 Broadcom Corporation
+ * Copyright (c) 2007-2008 Broadcom Corporation
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
#define BNX2X_MSG_STATS 0x20000 /* was: NETIF_MSG_TIMER */
#define NETIF_MSG_NVM 0x40000 /* was: NETIF_MSG_HW */
#define NETIF_MSG_DMAE 0x80000 /* was: NETIF_MSG_HW */
+#define BNX2X_MSG_SP 0x100000 /* was: NETIF_MSG_INTR */
+#define BNX2X_MSG_FP 0x200000 /* was: NETIF_MSG_INTR */
#define DP_LEVEL KERN_NOTICE /* was: KERN_DEBUG */
__LINE__, bp->dev?(bp->dev->name):"?", ##__args); \
} while (0)
+/* for logging (never masked) */
+#define BNX2X_LOG(__fmt, __args...) do { \
+ printk(KERN_NOTICE "[%s:%d(%s)]" __fmt, __FUNCTION__, \
+ __LINE__, bp->dev?(bp->dev->name):"?", ##__args); \
+ } while (0)
+
/* before we have a dev->name use dev_info() */
#define BNX2X_DEV_INFO(__fmt, __args...) do { \
if (bp->msglevel & NETIF_MSG_PROBE) \
#define BNX2X_FP_STATE_OPEN 0xa0000
#define BNX2X_FP_STATE_HALTING 0xb0000
#define BNX2X_FP_STATE_HALTED 0xc0000
-#define BNX2X_FP_STATE_DELETED 0xd0000
-#define BNX2X_FP_STATE_CLOSE_IRQ 0xe0000
int index;
struct eth_spe *spq;
dma_addr_t spq_mapping;
u16 spq_prod_idx;
- u16 dsb_sp_prod_idx;
struct eth_spe *spq_prod_bd;
struct eth_spe *spq_last_bd;
u16 *dsb_sp_prod;
*/
u8 stat_pending;
- /* End of fileds used in the performance code paths */
+ /* End of fields used in the performance code paths */
int panic;
int msglevel;
spinlock_t phy_lock;
struct work_struct reset_task;
- u16 in_reset_task;
-
struct work_struct sp_task;
struct timer_list timer;
#define CHIP_ID(bp) (((bp)->chip_id) & 0xfffffff0)
#define CHIP_NUM(bp) (((bp)->chip_id) & 0xffff0000)
-#define CHIP_NUM_5710 0x57100000
#define CHIP_REV(bp) (((bp)->chip_id) & 0x0000f000)
#define CHIP_REV_Ax 0x00000000
u32 fw_mb;
u32 hw_config;
- u32 serdes_config;
+ u32 board;
+ u32 serdes_config;
u32 lane_config;
u32 ext_phy_config;
#define XGXS_EXT_PHY_TYPE(bp) (bp->ext_phy_config & \
u8 tx_lane_swap;
u8 link_up;
+ u8 phy_link_up;
u32 supported;
/* link settings - missing defines */
#define SUPPORTED_2500baseT_Full (1 << 15)
-#define SUPPORTED_CX4 (1 << 16)
u32 phy_flags;
/*#define PHY_SERDES_FLAG 0x1*/
#define FLOW_CTRL_BOTH PORT_FEATURE_FLOW_CONTROL_BOTH
#define FLOW_CTRL_NONE PORT_FEATURE_FLOW_CONTROL_NONE
- u32 pause_mode;
-#define PAUSE_NONE 0
-#define PAUSE_SYMMETRIC 1
-#define PAUSE_ASYMMETRIC 2
-#define PAUSE_BOTH 3
-
u32 advertising;
/* link settings - missing defines */
#define ADVERTISED_2500baseT_Full (1 << 15)
-#define ADVERTISED_CX4 (1 << 16)
u32 link_status;
u32 line_speed;
#define NVRAM_TIMEOUT_COUNT 30000
#define NVRAM_PAGE_SIZE 256
+ u8 wol;
+
int rx_ring_size;
u16 tx_quick_cons_trip_int;
#endif
char *name;
- u16 bus_speed_mhz;
- u8 wol;
- u8 pad;
/* used to synchronize stats collecting */
int stats_state;
#define MAX_SPQ_PENDING 8
-#define BNX2X_NUM_STATS 31
-#define BNX2X_NUM_TESTS 2
+#define BNX2X_NUM_STATS 34
+#define BNX2X_NUM_TESTS 1
#define DPM_TRIGER_TYPE 0x40
DPM_TRIGER_TYPE); \
} while (0)
+/* PCIE link and speed */
+#define PCICFG_LINK_WIDTH 0x1f00000
+#define PCICFG_LINK_WIDTH_SHIFT 20
+#define PCICFG_LINK_SPEED 0xf0000
+#define PCICFG_LINK_SPEED_SHIFT 16
+
+#define BMAC_CONTROL_RX_ENABLE 2
+
+#define pbd_tcp_flags(skb) (ntohl(tcp_flag_word(tcp_hdr(skb)))>>16 & 0xff)
/* stuff added to make the code fit 80Col */
#define LINK_16GTFD LINK_STATUS_SPEED_AND_DUPLEX_16GTFD
#define LINK_16GXFD LINK_STATUS_SPEED_AND_DUPLEX_16GXFD
-#define NIG_STATUS_INTERRUPT_XGXS0_LINK10G \
+#define NIG_STATUS_XGXS0_LINK10G \
NIG_STATUS_INTERRUPT_PORT0_REG_STATUS_XGXS0_LINK10G
-#define NIG_XGXS0_LINK_STATUS \
+#define NIG_STATUS_XGXS0_LINK_STATUS \
NIG_STATUS_INTERRUPT_PORT0_REG_STATUS_XGXS0_LINK_STATUS
-#define NIG_XGXS0_LINK_STATUS_SIZE \
+#define NIG_STATUS_XGXS0_LINK_STATUS_SIZE \
NIG_STATUS_INTERRUPT_PORT0_REG_STATUS_XGXS0_LINK_STATUS_SIZE
-#define NIG_SERDES0_LINK_STATUS \
+#define NIG_STATUS_SERDES0_LINK_STATUS \
NIG_STATUS_INTERRUPT_PORT0_REG_STATUS_SERDES0_LINK_STATUS
#define NIG_MASK_MI_INT \
NIG_MASK_INTERRUPT_PORT0_REG_MASK_EMAC0_MISC_MI_INT