/* bnx2.h: Broadcom NX2 network driver.
*
- * Copyright (c) 2004, 2005 Broadcom Corporation
+ * Copyright (c) 2004, 2005, 2006 Broadcom Corporation
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
#ifndef BNX2_H
#define BNX2_H
-#include <linux/config.h>
-
-#include <linux/module.h>
-#include <linux/moduleparam.h>
-
-#include <linux/kernel.h>
-#include <linux/timer.h>
-#include <linux/errno.h>
-#include <linux/ioport.h>
-#include <linux/slab.h>
-#include <linux/interrupt.h>
-#include <linux/pci.h>
-#include <linux/init.h>
-#include <linux/netdevice.h>
-#include <linux/etherdevice.h>
-#include <linux/skbuff.h>
-#include <linux/dma-mapping.h>
-#include <asm/bitops.h>
-#include <asm/io.h>
-#include <asm/irq.h>
-#include <linux/delay.h>
-#include <asm/byteorder.h>
-#include <linux/time.h>
-#include <linux/ethtool.h>
-#include <linux/mii.h>
-#ifdef NETIF_F_HW_VLAN_TX
-#include <linux/if_vlan.h>
-#define BCM_VLAN 1
-#endif
-#ifdef NETIF_F_TSO
-#include <net/ip.h>
-#include <net/tcp.h>
-#include <net/checksum.h>
-#define BCM_TSO 1
-#endif
-#include <linux/workqueue.h>
-#include <linux/crc32.h>
-#include <linux/prefetch.h>
-
/* Hardware data structures and register definitions automatically
* generated from RTL code. Do not modify.
*/
* l2_fhdr definition
*/
struct l2_fhdr {
-#if defined(__BIG_ENDIAN)
- u16 l2_fhdr_errors;
- u16 l2_fhdr_status;
-#elif defined(__LITTLE_ENDIAN)
- u16 l2_fhdr_status;
- u16 l2_fhdr_errors;
-#endif
- #define L2_FHDR_ERRORS_BAD_CRC (1<<1)
- #define L2_FHDR_ERRORS_PHY_DECODE (1<<2)
- #define L2_FHDR_ERRORS_ALIGNMENT (1<<3)
- #define L2_FHDR_ERRORS_TOO_SHORT (1<<4)
- #define L2_FHDR_ERRORS_GIANT_FRAME (1<<5)
-
+ u32 l2_fhdr_status;
#define L2_FHDR_STATUS_RULE_CLASS (0x7<<0)
#define L2_FHDR_STATUS_RULE_P2 (1<<3)
#define L2_FHDR_STATUS_RULE_P3 (1<<4)
#define L2_FHDR_STATUS_TCP_SEGMENT (1<<14)
#define L2_FHDR_STATUS_UDP_DATAGRAM (1<<15)
+ #define L2_FHDR_ERRORS_BAD_CRC (1<<17)
+ #define L2_FHDR_ERRORS_PHY_DECODE (1<<18)
+ #define L2_FHDR_ERRORS_ALIGNMENT (1<<19)
+ #define L2_FHDR_ERRORS_TOO_SHORT (1<<20)
+ #define L2_FHDR_ERRORS_GIANT_FRAME (1<<21)
+ #define L2_FHDR_ERRORS_TCP_XSUM (1<<28)
+ #define L2_FHDR_ERRORS_UDP_XSUM (1<<31)
+
u32 l2_fhdr_hash;
#if defined(__BIG_ENDIAN)
u16 l2_fhdr_pkt_len;
#define TX_DESC_CNT (BCM_PAGE_SIZE / sizeof(struct tx_bd))
#define MAX_TX_DESC_CNT (TX_DESC_CNT - 1)
+#define MAX_RX_RINGS 4
#define RX_DESC_CNT (BCM_PAGE_SIZE / sizeof(struct rx_bd))
#define MAX_RX_DESC_CNT (RX_DESC_CNT - 1)
+#define MAX_TOTAL_RX_DESC_CNT (MAX_RX_DESC_CNT * MAX_RX_RINGS)
#define NEXT_TX_BD(x) (((x) & (MAX_TX_DESC_CNT - 1)) == \
(MAX_TX_DESC_CNT - 1)) ? \
(MAX_RX_DESC_CNT - 1)) ? \
(x) + 2 : (x) + 1
-#define RX_RING_IDX(x) ((x) & MAX_RX_DESC_CNT)
+#define RX_RING_IDX(x) ((x) & bp->rx_max_ring_idx)
+#define RX_RING(x) (((x) & ~MAX_RX_DESC_CNT) >> 8)
+#define RX_IDX(x) ((x) & MAX_RX_DESC_CNT)
/* Context size. */
#define CTX_SHIFT 7
struct status_block *status_blk;
u32 last_status_idx;
- struct tx_bd *tx_desc_ring;
- struct sw_bd *tx_buf_ring;
- u32 tx_prod_bseq;
- u16 tx_prod;
- u16 tx_cons;
- int tx_ring_size;
+ u32 flags;
+#define PCIX_FLAG 1
+#define PCI_32BIT_FLAG 2
+#define ONE_TDMA_FLAG 4 /* no longer used */
+#define NO_WOL_FLAG 8
+#define USING_DAC_FLAG 0x10
+#define USING_MSI_FLAG 0x20
+#define ASF_ENABLE_FLAG 0x40
- u16 hw_tx_cons;
- u16 hw_rx_cons;
+ /* Put tx producer and consumer fields in separate cache lines. */
+
+ u32 tx_prod_bseq __attribute__((aligned(L1_CACHE_BYTES)));
+ u16 tx_prod;
+
+ struct tx_bd *tx_desc_ring;
+ struct sw_bd *tx_buf_ring;
+ int tx_ring_size;
+
+ u16 tx_cons __attribute__((aligned(L1_CACHE_BYTES)));
+ u16 hw_tx_cons;
#ifdef BCM_VLAN
struct vlan_group *vlgrp;
u32 rx_offset;
u32 rx_buf_use_size; /* useable size */
u32 rx_buf_size; /* with alignment */
- struct rx_bd *rx_desc_ring;
- struct sw_bd *rx_buf_ring;
+ u32 rx_max_ring_idx;
+
u32 rx_prod_bseq;
u16 rx_prod;
u16 rx_cons;
+ u16 hw_rx_cons;
u32 rx_csum;
+ struct sw_bd *rx_buf_ring;
+ struct rx_bd *rx_desc_ring[MAX_RX_RINGS];
+
/* Only used to synchronize netif_stop_queue/wake_queue when tx */
/* ring is full */
spinlock_t tx_lock;
- /* End of fileds used in the performance code paths. */
+ /* End of fields used in the performance code paths. */
char *name;
/* Used to synchronize phy accesses. */
spinlock_t phy_lock;
- u32 flags;
-#define PCIX_FLAG 1
-#define PCI_32BIT_FLAG 2
-#define ONE_TDMA_FLAG 4 /* no longer used */
-#define NO_WOL_FLAG 8
-#define USING_DAC_FLAG 0x10
-#define USING_MSI_FLAG 0x20
-
u32 phy_flags;
#define PHY_SERDES_FLAG 1
#define PHY_CRC_FIX_FLAG 2
#define CHIP_ID_5706_A2 0x57060020
#define CHIP_ID_5708_A0 0x57080000
#define CHIP_ID_5708_B0 0x57081000
+#define CHIP_ID_5708_B1 0x57081010
#define CHIP_BOND_ID(bp) (((bp)->chip_id) & 0xf)
u16 bus_speed_mhz;
u8 wol;
- u8 fw_timed_out;
+ u8 pad;
u16 fw_wr_seq;
u16 fw_drv_pulse_wr_seq;
dma_addr_t tx_desc_mapping;
+ int rx_max_ring;
int rx_ring_size;
- dma_addr_t rx_desc_mapping;
+ dma_addr_t rx_desc_mapping[MAX_RX_RINGS];
u16 tx_quick_cons_trip;
u16 tx_quick_cons_trip_int;
struct statistics_block *stats_blk;
dma_addr_t stats_blk_mapping;
+ u32 hc_cmd;
u32 rx_mode;
u16 req_line_speed;
struct net_device_stats net_stats;
struct flash_spec *flash_info;
+ u32 flash_size;
+
+ int status_stats_size;
};
static u32 bnx2_reg_rd_ind(struct bnx2 *bp, u32 offset);
* the firmware has timed out, the driver will assume there is no firmware
* running and there won't be any firmware-driver synchronization during a
* driver reset. */
-#define FW_ACK_TIME_OUT_MS 50
+#define FW_ACK_TIME_OUT_MS 100
#define BNX2_DRV_RESET_SIGNATURE 0x00000000
#define BNX2_SHARED_HW_CFG_LED_MODE_GPHY1 0x100
#define BNX2_SHARED_HW_CFG_LED_MODE_GPHY2 0x200
+#define BNX2_SHARED_HW_CFG_CONFIG2 0x00000040
+#define BNX2_SHARED_HW_CFG2_NVM_SIZE_MASK 0x00fff000
+
#define BNX2_DEV_INFO_BC_REV 0x0000004c
#define BNX2_PORT_HW_CFG_MAC_UPPER 0x00000050