#include <linux/delay.h>
#include <linux/crc32.h>
#include <linux/phy.h>
+
+#include <asm/cpu.h>
#include <asm/mipsregs.h>
#include <asm/irq.h>
#include <asm/io.h>
#include <asm/processor.h>
-#include <asm/mach-au1x00/au1000.h>
-#include <asm/cpu.h>
+#include <au1000.h>
+#include <prom.h>
+
#include "au1000_eth.h"
#ifdef AU1000_ETH_DEBUG
static void au1000_adjust_link(struct net_device *);
static void enable_mac(struct net_device *, int);
-// externs
-extern int get_ethernet_addr(char *ethernet_addr);
-extern void str2eaddr(unsigned char *ea, unsigned char *str);
-extern char * prom_getcmdline(void);
-
/*
* Theory of operation
*
static int num_ifs;
/*
- * Setup the base address and interupt of the Au1xxx ethernet macs
+ * Setup the base address and interrupt of the Au1xxx ethernet macs
* based on cpu type and whether the interface is enabled in sys_pinfunc
* register. The last interface is enabled if SYS_PF_NI2 (bit 4) is 0.
*/
struct au1000_private *aup = NULL;
struct net_device *dev = NULL;
db_dest_t *pDB, *pDBfree;
- char *pmac, *argptr;
char ethaddr[6];
int irq, i, err;
u32 base, macen;
au_macs[port_num] = aup;
if (port_num == 0) {
- /* Check the environment variables first */
- if (get_ethernet_addr(ethaddr) == 0)
+ if (prom_get_ethernet_addr(ethaddr) == 0)
memcpy(au1000_mac_addr, ethaddr, sizeof(au1000_mac_addr));
else {
- /* Check command line */
- argptr = prom_getcmdline();
- if ((pmac = strstr(argptr, "ethaddr=")) == NULL)
- printk(KERN_INFO "%s: No MAC address found\n",
- dev->name);
+ printk(KERN_INFO "%s: No MAC address found\n",
+ dev->name);
/* Use the hard coded MAC addresses */
- else {
- str2eaddr(ethaddr, pmac + strlen("ethaddr="));
- memcpy(au1000_mac_addr, ethaddr,
- sizeof(au1000_mac_addr));
- }
}
setup_hw_rings(aup, MAC0_RX_DMA_ADDR, MAC0_TX_DMA_ADDR);