[PATCH] drivers/net: remove superfluous memset

[linux-2.6] / drivers / net / Kconfig

diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
index 40ff9a5269a26097925103ce7f79c781d36d8905..734f8403c806cd0fcf5a22757991d2b26fbebdfb 100644 (file)
--- a/drivers/net/Kconfig
+++ b/drivers/net/Kconfig
@@ -486,26 +486,6 @@ config SGI_IOC3_ETH
          the Ethernet-HOWTO, available from
          <http://www.tldp.org/docs.html#howto>.
 
-config SGI_IOC3_ETH_HW_RX_CSUM
-       bool "Receive hardware checksums"
-       depends on SGI_IOC3_ETH && INET
-       default y
-       help
-         The SGI IOC3 network adapter supports TCP and UDP checksums in
-         hardware to offload processing of these checksums from the CPU.  At
-         the moment only acceleration of IPv4 is supported.  This option
-         enables offloading for checksums on receive.  If unsure, say Y.
-
-config SGI_IOC3_ETH_HW_TX_CSUM
-       bool "Transmit hardware checksums"
-       depends on SGI_IOC3_ETH && INET
-       default y
-       help
-         The SGI IOC3 network adapter supports TCP and UDP checksums in
-         hardware to offload processing of these checksums from the CPU.  At
-         the moment only acceleration of IPv4 is supported.  This option
-         enables offloading for checksums on transmit.  If unsure, say Y.
-
 config MIPS_SIM_NET
        tristate "MIPS simulator Network device"
        depends on MIPS_SIM
@@ -3082,6 +3062,16 @@ config NETCONSOLE
        If you want to log kernel messages over the network, enable this.
        See <file:Documentation/networking/netconsole.txt> for details.
 
+config NETCONSOLE_DYNAMIC
+       bool "Dynamic reconfiguration of logging targets (EXPERIMENTAL)"
+       depends on NETCONSOLE && SYSFS && EXPERIMENTAL
+       select CONFIGFS_FS
+       help
+         This option enables the ability to dynamically reconfigure target
+         parameters (interface, IP addresses, port numbers, MAC addresses)
+         at runtime through a userspace interface exported using configfs.
+         See <file:Documentation/networking/netconsole.txt> for details.
+
 config NETPOLL
        def_bool NETCONSOLE