# linux/drivers/mtd/onenand/Kconfig
#
-menu "OneNAND Flash Device Drivers"
- depends on MTD != n
-
-config MTD_ONENAND
+menuconfig MTD_ONENAND
tristate "OneNAND Device Support"
depends on MTD
help
This enables support for accessing all type of OneNAND flash
devices. For further information see
- <http://www.samsung.com/Products/Semiconductor/Flash/OneNAND_TM/index.htm>.
+ <http://www.samsung.com/Products/Semiconductor/OneNAND/index.htm>
+
+if MTD_ONENAND
config MTD_ONENAND_VERIFY_WRITE
bool "Verify OneNAND page writes"
- depends on MTD_ONENAND
help
This adds an extra check when data is written to the flash. The
OneNAND flash device internally checks only bits transitioning
from 1 to 0. There is a rare possibility that even though the
device thinks the write was successful, a bit could have been
- flipped accidentaly due to device wear or something else.
+ flipped accidentally due to device wear or something else.
config MTD_ONENAND_GENERIC
tristate "OneNAND Flash device via platform device driver"
- depends on MTD_ONENAND && ARM
+ depends on ARM
help
Support for OneNAND flash via platform device driver.
-config MTD_ONENAND_SYNC_READ
- bool "OneNAND Sync. Burst Read Support"
- depends on ARCH_OMAP
+config MTD_ONENAND_OTP
+ bool "OneNAND OTP Support"
help
- This enables support for Sync. Burst Read.
+ One Block of the NAND Flash Array memory is reserved as
+ a One-Time Programmable Block memory area.
+ Also, 1st Block of NAND Flash Array can be used as OTP.
+
+ The OTP block can be read, programmed and locked using the same
+ operations as any other NAND Flash Array memory block.
+ OTP block cannot be erased.
+
+ OTP block is fully-guaranteed to be a valid block.
-endmenu
+endif # MTD_ONENAND