particular board as well as the bus width, either statically
with config options or at run-time.
+ To compile this driver as a module, choose M here: the
+ module will be called physmap.
+
config MTD_PHYSMAP_START
hex "Physical start address of flash mapping"
depends on MTD_PHYSMAP
Sun Microsystems boardsets. This driver will require CFI support
in the kernel, so if you did not enable CFI previously, do that now.
-config MTD_PNC2000
- tristate "CFI Flash device mapped on Photron PNC-2000"
- depends on X86 && MTD_CFI && MTD_PARTITIONS
- help
- PNC-2000 is the name of Network Camera product from PHOTRON
- Ltd. in Japan. It uses CFI-compliant flash.
-
config MTD_SC520CDP
tristate "CFI Flash device mapped on AMD SC520 CDP"
depends on X86 && MTD_CFI && MTD_CONCAT
config MTD_SOLUTIONENGINE
tristate "CFI Flash device mapped on Hitachi SolutionEngine"
- depends on SUPERH && MTD_CFI && MTD_REDBOOT_PARTS
+ depends on SUPERH && SOLUTION_ENGINE && MTD_CFI && MTD_REDBOOT_PARTS
help
This enables access to the flash chips on the Hitachi SolutionEngine and
similar boards. Say 'Y' if you are building a kernel for such a board.
This enables access to the flash chips on the Hynix evaluation boards.
If you have such a board, say 'Y'.
-config MTD_MPC1211
- tristate "CFI Flash device mapped on Interface MPC-1211"
- depends on SH_MPC1211 && MTD_CFI
- help
- This enables access to the flash chips on the Interface MPC-1211(CTP/PCI/MPC-SH02).
- If you have such a board, say 'Y'.
-
config MTD_OMAP_NOR
tristate "TI OMAP board mappings"
depends on MTD_CFI && ARCH_OMAP
default "4"
config MTD_SHARP_SL
- bool "ROM mapped on Sharp SL Series"
+ tristate "ROM mapped on Sharp SL Series"
depends on ARCH_PXA
help
This enables access to the flash chip on the Sharp SL Series of PDAs.