/* Module Parameters */
static int phys_dma = 1;
-module_param(phys_dma, int, 0644);
+module_param(phys_dma, int, 0444);
MODULE_PARM_DESC(phys_dma, "Enable physical dma (default = 1).");
static void dma_trm_tasklet(unsigned long data);
/* Initialize IR Legacy DMA channel mask */
ohci->ir_legacy_channels = 0;
- /*
- * Accept AT requests from all nodes. This probably
- * will have to be controlled from the subsystem
- * on a per node basis.
- */
- reg_write(ohci,OHCI1394_AsReqFilterHiSet, 0x80000000);
+ /* Accept AR requests from all nodes */
+ reg_write(ohci, OHCI1394_AsReqFilterHiSet, 0x80000000);
+
+ /* Set the address range of the physical response unit.
+ * Most controllers do not implement it as a writable register though.
+ * They will keep a hardwired offset of 0x00010000 and show 0x0 as
+ * register content.
+ * To actually enable physical responses is the job of our interrupt
+ * handler which programs the physical request filter. */
+ reg_write(ohci, OHCI1394_PhyUpperBound,
+ OHCI1394_PHYS_UPPER_BOUND_PROGRAMMED >> 16);
+
+ DBGMSG("physUpperBoundOffset=%08x",
+ reg_read(ohci, OHCI1394_PhyUpperBound));
/* Specify AT retries */
reg_write(ohci, OHCI1394_ATRetries,
OHCI1394_reqTxComplete |
OHCI1394_isochRx |
OHCI1394_isochTx |
+ OHCI1394_postedWriteErr |
+ OHCI1394_cycleTooLong |
OHCI1394_cycleInconsistent);
/* Enable link */
reg_write(ohci, OHCI1394_HCControlSet, OHCI1394_HCControl_linkEnable);
buf = reg_read(ohci, OHCI1394_Version);
-#ifndef __sparc__
sprintf (irq_buf, "%d", ohci->dev->irq);
-#else
- sprintf (irq_buf, "%s", __irq_itoa(ohci->dev->irq));
-#endif
PRINT(KERN_INFO, "OHCI-1394 %d.%d (PCI): IRQ=[%s] "
"MMIO=[%lx-%lx] Max Packet=[%d] IR/IT contexts=[%d/%d]",
((((buf) >> 16) & 0xf) + (((buf) >> 20) & 0xf) * 10),
event &= ~OHCI1394_unrecoverableError;
}
-
+ if (event & OHCI1394_postedWriteErr) {
+ PRINT(KERN_ERR, "physical posted write error");
+ /* no recovery strategy yet, had to involve protocol drivers */
+ }
+ if (event & OHCI1394_cycleTooLong) {
+ if(printk_ratelimit())
+ PRINT(KERN_WARNING, "isochronous cycle too long");
+ else
+ DBGMSG("OHCI1394_cycleTooLong");
+ reg_write(ohci, OHCI1394_LinkControlSet,
+ OHCI1394_LinkControl_CycleMaster);
+ event &= ~OHCI1394_cycleTooLong;
+ }
if (event & OHCI1394_cycleInconsistent) {
/* We subscribe to the cycleInconsistent event only to
* clear the corresponding event bit... otherwise,
DBGMSG("OHCI1394_cycleInconsistent");
event &= ~OHCI1394_cycleInconsistent;
}
-
if (event & OHCI1394_busReset) {
/* The busReset event bit can't be cleared during the
* selfID phase, so we disable busReset interrupts, to
}
event &= ~OHCI1394_busReset;
}
-
if (event & OHCI1394_reqTxComplete) {
struct dma_trm_ctx *d = &ohci->at_req_context;
DBGMSG("Got reqTxComplete interrupt "
reg_write(ohci, OHCI1394_IntMaskSet, OHCI1394_busReset);
spin_unlock_irqrestore(&ohci->event_lock, flags);
- /* Accept Physical requests from all nodes. */
- reg_write(ohci,OHCI1394_AsReqFilterHiSet, 0xffffffff);
- reg_write(ohci,OHCI1394_AsReqFilterLoSet, 0xffffffff);
-
/* Turn on phys dma reception.
*
* TODO: Enable some sort of filtering management.
*/
if (phys_dma) {
- reg_write(ohci,OHCI1394_PhyReqFilterHiSet, 0xffffffff);
- reg_write(ohci,OHCI1394_PhyReqFilterLoSet, 0xffffffff);
- reg_write(ohci,OHCI1394_PhyUpperBound, 0xffff0000);
- } else {
- reg_write(ohci,OHCI1394_PhyReqFilterHiSet, 0x00000000);
- reg_write(ohci,OHCI1394_PhyReqFilterLoSet, 0x00000000);
+ reg_write(ohci, OHCI1394_PhyReqFilterHiSet,
+ 0xffffffff);
+ reg_write(ohci, OHCI1394_PhyReqFilterLoSet,
+ 0xffffffff);
}
DBGMSG("PhyReqFilter=%08x%08x",
- reg_read(ohci,OHCI1394_PhyReqFilterHiSet),
- reg_read(ohci,OHCI1394_PhyReqFilterLoSet));
+ reg_read(ohci, OHCI1394_PhyReqFilterHiSet),
+ reg_read(ohci, OHCI1394_PhyReqFilterLoSet));
hpsb_selfid_complete(host, phyid, isroot);
} else
* fail to report the right length. Anyway, the ohci spec
* clearly says it's 2kb, so this shouldn't be a problem. */
ohci_base = pci_resource_start(dev, 0);
- if (pci_resource_len(dev, 0) != OHCI1394_REGISTER_SIZE)
- PRINT(KERN_WARNING, "Unexpected PCI resource length of %lx!",
+ if (pci_resource_len(dev, 0) < OHCI1394_REGISTER_SIZE)
+ PRINT(KERN_WARNING, "PCI resource length of %lx too small!",
pci_resource_len(dev, 0));
/* Seems PCMCIA handles this internally. Not sure why. Seems
host->csr.max_rec = (reg_read(ohci, OHCI1394_BusOptions) >> 12) & 0xf;
host->csr.lnk_spd = reg_read(ohci, OHCI1394_BusOptions) & 0x7;
+ if (phys_dma) {
+ host->low_addr_space =
+ (u64) reg_read(ohci, OHCI1394_PhyUpperBound) << 16;
+ if (!host->low_addr_space)
+ host->low_addr_space = OHCI1394_PHYS_UPPER_BOUND_FIXED;
+ }
+ host->middle_addr_space = OHCI1394_MIDDLE_ADDRESS_SPACE;
+
/* Tell the highlevel this host is ready */
if (hpsb_add_host(host))
FAIL(-ENOMEM, "Failed to register host with highlevel");
case OHCI_INIT_HAVE_TXRX_BUFFERS__MAYBE:
/* The ohci_soft_reset() stops all DMA contexts, so we
* dont need to do this. */
- /* Free AR dma */
free_dma_rcv_ctx(&ohci->ar_req_context);
free_dma_rcv_ctx(&ohci->ar_resp_context);
-
- /* Free AT dma */
free_dma_trm_ctx(&ohci->at_req_context);
free_dma_trm_ctx(&ohci->at_resp_context);
-
- /* Free IR dma */
free_dma_rcv_ctx(&ohci->ir_legacy_context);
-
- /* Free IT dma */
free_dma_trm_ctx(&ohci->it_legacy_context);
- /* Free IR legacy dma */
- free_dma_rcv_ctx(&ohci->ir_legacy_context);
-
-
case OHCI_INIT_HAVE_SELFID_BUFFER:
pci_free_consistent(ohci->dev, OHCI1394_SI_DMA_BUF_SIZE,
ohci->selfid_buf_cpu,
static int ohci1394_pci_resume (struct pci_dev *pdev)
{
#ifdef CONFIG_PPC_PMAC
- if (_machine == _MACH_Pmac) {
+ if (machine_is(powermac)) {
struct device_node *of_node;
/* Re-enable 1394 */
}
#endif /* CONFIG_PPC_PMAC */
+ pci_restore_state(pdev);
pci_enable_device(pdev);
return 0;
static int ohci1394_pci_suspend (struct pci_dev *pdev, pm_message_t state)
{
#ifdef CONFIG_PPC_PMAC
- if (_machine == _MACH_Pmac) {
+ if (machine_is(powermac)) {
struct device_node *of_node;
/* Disable 1394 */
}
#endif
+ pci_save_state(pdev);
+
return 0;
}