/*
* Set timing for this drive:
*/
- outb(timing, hwif->io_ports[IDE_SELECT_OFFSET]);
- (void)inb(hwif->io_ports[IDE_STATUS_OFFSET]);
+ outb(timing, hwif->io_ports.device_addr);
+ (void)inb(hwif->io_ports.status_addr);
#ifdef DEBUG
printk("ht6560b: %s: select=%#x timing=%#x\n",
drive->name, select, timing);
{
int active_time, recovery_time;
int active_cycles, recovery_cycles;
- int bus_speed = ide_vlb_clk ? ide_vlb_clk : system_bus_clock();
+ int bus_speed = ide_vlb_clk ? ide_vlb_clk : 50;
if (pio) {
unsigned int cycle_time;
+ struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
cycle_time = ide_pio_cycle_time(drive, pio);
* actual cycle time for recovery and activity
* according system bus speed.
*/
- active_time = ide_pio_timings[pio].active_time;
- recovery_time = cycle_time
- - active_time
- - ide_pio_timings[pio].setup_time;
+ active_time = t->active;
+ recovery_time = cycle_time - active_time - t->setup;
/*
* Cycle times should be Vesa bus cycles
*/
#endif
}
-static void __init ht6560b_port_init_devs(ide_hwif_t *hwif)
+static void __init ht6560b_init_dev(ide_drive_t *drive)
{
+ ide_hwif_t *hwif = drive->hwif;
/* Setting default configurations for drives. */
int t = (HT_CONFIG_DEFAULT << 8) | HT_TIMING_DEFAULT;
if (hwif->channel)
t |= (HT_SECONDARY_IF << 8);
- hwif->drives[0].drive_data = t;
- hwif->drives[1].drive_data = t;
+ drive->drive_data = t;
}
static int probe_ht6560b;
MODULE_PARM_DESC(probe, "probe for HT6560B chipset");
static const struct ide_port_ops ht6560b_port_ops = {
- .port_init_devs = ht6560b_port_init_devs,
+ .init_dev = ht6560b_init_dev,
.set_pio_mode = ht6560b_set_pio_mode,
.selectproc = ht6560b_selectproc,
};
.port_ops = &ht6560b_port_ops,
.host_flags = IDE_HFLAG_SERIALIZE | /* is this needed? */
IDE_HFLAG_NO_DMA |
- IDE_HFLAG_NO_AUTOTUNE |
IDE_HFLAG_ABUSE_PREFETCH,
.pio_mask = ATA_PIO4,
};