# Andre Hedrick <andre@linux-ide.org>
#
+if BLOCK
+
menu "ATA/ATAPI/MFM/RLL support"
config IDE
config IDE_MAX_HWIFS
int "Max IDE interfaces"
- depends on ALPHA || SUPERH || IA64
+ depends on ALPHA || SUPERH || IA64 || EMBEDDED
default 4
help
This is the maximum number of IDE hardware interfaces that will
ide-probe at boot. It is reported to support DVD II drives, by the
manufacturer.
+config BLK_DEV_JMICRON
+ tristate "JMicron JMB36x support"
+ help
+ Basic support for the JMicron ATA controllers. For full support
+ use the libata drivers.
+
config BLK_DEV_SC1200
tristate "National SCx200 chipset support"
help
the kernel to change PIO, DMA and UDMA speeds and to configure
the chip to optimum performance.
-config BLK_DEV_IT8172
- bool "IT8172 IDE support"
- depends on (MIPS_ITE8172 || MIPS_IVR)
- help
- Say Y here to support the on-board IDE controller on the Integrated
- Technology Express, Inc. ITE8172 SBC. Vendor page at
- <http://www.ite.com.tw/ia/brief_it8172bsp.htm>; picture of the
- board at <http://www.mvista.com/partners/semiconductor/ite.html>.
-
config BLK_DEV_IT821X
tristate "IT821X IDE support"
help
config BLK_DEV_SGIIOC4
tristate "Silicon Graphics IOC4 chipset ATA/ATAPI support"
depends on (IA64_SGI_SN2 || IA64_GENERIC) && SGI_IOC4
+ select IDEPCI_SHARE_IRQ
help
This driver adds PIO & MultiMode DMA-2 support for the SGI IOC4
chipset, which has one channel and can support two devices.
to transfer data to and from memory. Saying Y is safe and improves
performance.
-config BLK_DEV_IDE_PMAC_BLINK
- bool "Blink laptop LED on drive activity (DEPRECATED)"
- depends on BLK_DEV_IDE_PMAC && ADB_PMU
- select ADB_PMU_LED
- select LEDS_TRIGGERS
- select LEDS_TRIGGER_IDE_DISK
- help
- This option enables the use of the sleep LED as a hard drive
- activity LED.
- This option is deprecated, it only selects ADB_PMU_LED and
- LEDS_TRIGGER_IDE_DISK and changes the code in the new led class
- device to default to the ide-disk trigger (which should be set
- from userspace via sysfs).
-
config BLK_DEV_IDE_SWARM
tristate "IDE for Sibyte evaluation boards"
depends on SIBYTE_SB1xxx_SOC
endif
endmenu
+
+endif