edac: core fix redundant sysfs controls to parameters

[linux-2.6] / drivers / hwmon / abituguru3.c

diff --git a/drivers/hwmon/abituguru3.c b/drivers/hwmon/abituguru3.c
index f2086e99a9cb49e97917df720170af53f781f677..f00f497b9ca9b38ed615a17955d42da607601214 100644 (file)
--- a/drivers/hwmon/abituguru3.c
+++ b/drivers/hwmon/abituguru3.c
@@ -30,6 +30,7 @@
 #include <linux/platform_device.h>
 #include <linux/hwmon.h>
 #include <linux/hwmon-sysfs.h>
+#include <linux/dmi.h>
 #include <asm/io.h>
 
 /* uGuru3 bank addresses */
@@ -1112,11 +1113,12 @@ static int __init abituguru3_detect(void)
 {
        /* See if there is an uguru3 there. An idle uGuru3 will hold 0x00 or
           0x08 at DATA and 0xAC at CMD. Sometimes the uGuru3 will hold 0x05
-          at CMD instead, why is unknown. So we test for 0x05 too. */
+          or 0x55 at CMD instead, why is unknown. */
        u8 data_val = inb_p(ABIT_UGURU3_BASE + ABIT_UGURU3_DATA);
        u8 cmd_val = inb_p(ABIT_UGURU3_BASE + ABIT_UGURU3_CMD);
        if (((data_val == 0x00) || (data_val == 0x08)) &&
-                       ((cmd_val == 0xAC) || (cmd_val == 0x05)))
+                       ((cmd_val == 0xAC) || (cmd_val == 0x05) ||
+                        (cmd_val == 0x55)))
                return ABIT_UGURU3_BASE;
 
        ABIT_UGURU3_DEBUG("no Abit uGuru3 found, data = 0x%02X, cmd = "
@@ -1139,6 +1141,15 @@ static int __init abituguru3_init(void)
        int address, err;
        struct resource res = { .flags = IORESOURCE_IO };
 
+#ifdef CONFIG_DMI
+       const char *board_vendor = dmi_get_system_info(DMI_BOARD_VENDOR);
+
+       /* safety check, refuse to load on non Abit motherboards */
+       if (!force && (!board_vendor ||
+                       strcmp(board_vendor, "http://www.abit.com.tw/")))
+               return -ENODEV;
+#endif
+
        address = abituguru3_detect();
        if (address < 0)
                return address;