menu "Hardware crypto devices"
config CRYPTO_DEV_PADLOCK
- tristate "Support for VIA PadLock ACE"
+ bool "Support for VIA PadLock ACE"
depends on X86_32
select CRYPTO_ALGAPI
- default m
+ default y
help
Some VIA processors come with an integrated crypto engine
(so called VIA PadLock ACE, Advanced Cryptography Engine)
The instructions are used only when the CPU supports them.
Otherwise software encryption is used.
- Selecting M for this option will compile a helper module
- padlock.ko that should autoload all below configured
- algorithms. Don't worry if your hardware does not support
- some or all of them. In such case padlock.ko will
- simply write a single line into the kernel log informing
- about its failure but everything will keep working fine.
-
- If you are unsure, say M. The compiled module will be
- called padlock.ko
-
config CRYPTO_DEV_PADLOCK_AES
tristate "PadLock driver for AES algorithm"
depends on CRYPTO_DEV_PADLOCK
config CRYPTO_DEV_GEODE
tristate "Support for the Geode LX AES engine"
- depends on CRYPTO && X86_32 && PCI
+ depends on X86_32 && PCI
select CRYPTO_ALGAPI
select CRYPTO_BLKCIPHER
default m
help
Say 'Y' here to use the AMD Geode LX processor on-board AES
- engine for the CryptoAPI AES alogrithm.
+ engine for the CryptoAPI AES algorithm.
To compile this driver as a module, choose M here: the module
will be called geode-aes.
+config ZCRYPT
+ tristate "Support for PCI-attached cryptographic adapters"
+ depends on S390
+ select ZCRYPT_MONOLITHIC if ZCRYPT="y"
+ default "m"
+ help
+ Select this option if you want to use a PCI-attached cryptographic
+ adapter like:
+ + PCI Cryptographic Accelerator (PCICA)
+ + PCI Cryptographic Coprocessor (PCICC)
+ + PCI-X Cryptographic Coprocessor (PCIXCC)
+ + Crypto Express2 Coprocessor (CEX2C)
+ + Crypto Express2 Accelerator (CEX2A)
+
+config ZCRYPT_MONOLITHIC
+ bool "Monolithic zcrypt module"
+ depends on ZCRYPT="m"
+ help
+ Select this option if you want to have a single module z90crypt.ko
+ that contains all parts of the crypto device driver (ap bus,
+ request router and all the card drivers).
+
endmenu