-menu "Hardware crypto devices"
+
+menuconfig CRYPTO_HW
+ bool "Hardware crypto devices"
+ default y
+
+if CRYPTO_HW
config CRYPTO_DEV_PADLOCK
tristate "Support for VIA PadLock ACE"
The instructions are used only when the CPU supports them.
Otherwise software encryption is used.
- Selecting M for this option will compile a helper module
- padlock.ko that should autoload all below configured
- algorithms. Don't worry if your hardware does not support
- some or all of them. In such case padlock.ko will
- simply write a single line into the kernel log informing
- about its failure but everything will keep working fine.
-
- If you are unsure, say M. The compiled module will be
- called padlock.ko
-
config CRYPTO_DEV_PADLOCK_AES
tristate "PadLock driver for AES algorithm"
depends on CRYPTO_DEV_PADLOCK
config CRYPTO_DEV_GEODE
tristate "Support for the Geode LX AES engine"
- depends on CRYPTO && X86_32 && PCI
+ depends on X86_32 && PCI
select CRYPTO_ALGAPI
select CRYPTO_BLKCIPHER
default m
help
Say 'Y' here to use the AMD Geode LX processor on-board AES
- engine for the CryptoAPI AES alogrithm.
+ engine for the CryptoAPI AES algorithm.
To compile this driver as a module, choose M here: the module
will be called geode-aes.
-endmenu
+config ZCRYPT
+ tristate "Support for PCI-attached cryptographic adapters"
+ depends on S390
+ select ZCRYPT_MONOLITHIC if ZCRYPT="y"
+ default "m"
+ help
+ Select this option if you want to use a PCI-attached cryptographic
+ adapter like:
+ + PCI Cryptographic Accelerator (PCICA)
+ + PCI Cryptographic Coprocessor (PCICC)
+ + PCI-X Cryptographic Coprocessor (PCIXCC)
+ + Crypto Express2 Coprocessor (CEX2C)
+ + Crypto Express2 Accelerator (CEX2A)
+
+config ZCRYPT_MONOLITHIC
+ bool "Monolithic zcrypt module"
+ depends on ZCRYPT="m"
+ help
+ Select this option if you want to have a single module z90crypt.ko
+ that contains all parts of the crypto device driver (ap bus,
+ request router and all the card drivers).
+
+endif # CRYPTO_HW