if (!(pp->flags & NV_ADMA_PORT_REGISTER_MODE))
return;
-
+
WARN_ON(pp->flags & NV_ADMA_ATAPI_SETUP_COMPLETE);
tmp = readw(mmio + NV_ADMA_CTL);
/* Subtract 1 since an extra entry may be needed for padding, see
libata-scsi.c */
sg_tablesize = LIBATA_MAX_PRD - 1;
-
+
/* Since the legacy DMA engine is in use, we need to disable ADMA
on the port. */
adma_enable = 0;
sg_tablesize = NV_ADMA_SGTBL_TOTAL_LEN;
adma_enable = 1;
}
-
+
pci_read_config_dword(pdev, NV_MCP_SATA_CFG_20, ¤t_reg);
if(ap->port_no == 1)
else
config_mask = NV_MCP_SATA_CFG_20_PORT0_EN |
NV_MCP_SATA_CFG_20_PORT0_PWB_EN;
-
+
if(adma_enable) {
new_reg = current_reg | config_mask;
pp->flags &= ~NV_ADMA_ATAPI_SETUP_COMPLETE;
new_reg = current_reg & ~config_mask;
pp->flags |= NV_ADMA_ATAPI_SETUP_COMPLETE;
}
-
+
if(current_reg != new_reg)
pci_write_config_dword(pdev, NV_MCP_SATA_CFG_20, new_reg);
-
+
blk_queue_bounce_limit(sdev->request_queue, bounce_limit);
blk_queue_segment_boundary(sdev->request_queue, segment_boundary);
blk_queue_max_hw_segments(sdev->request_queue, sg_tablesize);
handled++; /* irq handled if we got here */
}
}
-
+
if(notifier_clears[0] || notifier_clears[1]) {
/* Note: Both notifier clear registers must be written
if either is set, even if one is zero, according to NVIDIA. */
- writel(notifier_clears[0],
+ writel(notifier_clears[0],
nv_adma_notifier_clear_block(host->ports[0]));
- writel(notifier_clears[1],
+ writel(notifier_clears[1],
nv_adma_notifier_clear_block(host->ports[1]));
}