if (ap->port_no && !pci_test_config_bits(pdev, &optidma_enable_bits))
return -ENOENT;
- return ata_std_prereset(link, deadline);
-}
-
-/**
- * optidma_probe_reset - probe reset
- * @ap: ATA port
- *
- * Perform the ATA probe and bus reset sequence plus specific handling
- * for this hardware. The Opti needs little handling - we have no UDMA66
- * capability that needs cable detection. All we must do is check the port
- * is enabled.
- */
-
-static void optidma_error_handler(struct ata_port *ap)
-{
- ata_bmdma_drive_eh(ap, optidma_pre_reset, ata_std_softreset, NULL, ata_std_postreset);
+ return ata_sff_prereset(link, deadline);
}
/**
.set_piomode = optidma_set_pio_mode,
.set_dmamode = optidma_set_dma_mode,
.set_mode = optidma_set_mode,
- .error_handler = optidma_error_handler,
+ .prereset = optidma_pre_reset,
};
static struct ata_port_operations optiplus_port_ops = {
static int optidma_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{
static const struct ata_port_info info_82c700 = {
- .sht = &optidma_sht,
.flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
.port_ops = &optidma_port_ops
};
static const struct ata_port_info info_82c700_udma = {
- .sht = &optidma_sht,
.flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
if (optiplus_with_udma(dev))
ppi[0] = &info_82c700_udma;
- return ata_pci_init_one(dev, ppi);
+ return ata_pci_sff_init_one(dev, ppi, &optidma_sht, NULL);
}
static const struct pci_device_id optidma[] = {