#include <linux/libata.h>
#define DRV_NAME "pata_cypress"
-#define DRV_VERSION "0.1.4"
+#define DRV_VERSION "0.1.5"
/* here are the offset definitions for the registers */
CY82_INDEX_TIMEOUT = 0x32
};
-static int cy82c693_pre_reset(struct ata_port *ap)
-{
- ap->cbl = ATA_CBL_PATA40;
- return ata_std_prereset(ap);
-}
-
-static void cy82c693_error_handler(struct ata_port *ap)
-{
- ata_bmdma_drive_eh(ap, cy82c693_pre_reset, ata_std_softreset, NULL, ata_std_postreset);
-}
-
/**
* cy82c693_set_piomode - set initial PIO mode data
* @ap: ATA interface
.slave_configure = ata_scsi_slave_config,
.slave_destroy = ata_scsi_slave_destroy,
.bios_param = ata_std_bios_param,
-#ifdef CONFIG_PM
- .resume = ata_scsi_device_resume,
- .suspend = ata_scsi_device_suspend,
-#endif
};
static struct ata_port_operations cy82c693_port_ops = {
.freeze = ata_bmdma_freeze,
.thaw = ata_bmdma_thaw,
- .error_handler = cy82c693_error_handler,
+ .error_handler = ata_bmdma_error_handler,
.post_internal_cmd = ata_bmdma_post_internal_cmd,
+ .cable_detect = ata_cable_40wire,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
static int cy82c693_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
{
- static struct ata_port_info info = {
+ static const struct ata_port_info info = {
.sht = &cy82c693_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SRST,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
.port_ops = &cy82c693_port_ops
};
- static struct ata_port_info *port_info[1] = { &info };
+ const struct ata_port_info *ppi[] = { &info, &ata_dummy_port_info };
/* Devfn 1 is the ATA primary. The secondary is magic and on devfn2.
For the moment we don't handle the secondary. FIXME */
if (PCI_FUNC(pdev->devfn) != 1)
return -ENODEV;
- return ata_pci_init_one(pdev, port_info, 1);
+ return ata_pci_init_one(pdev, ppi);
}
static const struct pci_device_id cy82c693[] = {