int acpi_numa __initdata;
-#if (defined(CONFIG_ACPI_HOTPLUG_MEMORY) || \
- defined(CONFIG_ACPI_HOTPLUG_MEMORY_MODULE)) \
- && !defined(CONFIG_MEMORY_HOTPLUG)
-#define RESERVE_HOTADD 1
-#endif
-
static struct acpi_table_slit *acpi_slit;
static nodemask_t nodes_parsed __initdata;
static struct bootnode nodes[MAX_NUMNODES] __initdata;
-static struct bootnode nodes_add[MAX_NUMNODES] __initdata;
+static struct bootnode nodes_add[MAX_NUMNODES];
static int found_add_area __initdata;
int hotadd_percent __initdata = 0;
-#ifndef RESERVE_HOTADD
-#define hotadd_percent 0 /* Ignore all settings */
-#endif
/* Too small nodes confuse the VM badly. Usually they result
from BIOS bugs. */
apicid_to_node[i] = NUMA_NO_NODE;
for (i = 0; i < MAX_NUMNODES; i++)
nodes_add[i].start = nodes[i].end = 0;
+ remove_all_active_ranges();
}
static __init inline int srat_disabled(void)
static __init int slit_valid(struct acpi_table_slit *slit)
{
int i, j;
- int d = slit->localities;
+ int d = slit->locality_count;
for (i = 0; i < d; i++) {
for (j = 0; j < d; j++) {
u8 val = slit->entry[d*i + j];
/* Callback for Proximity Domain -> LAPIC mapping */
void __init
-acpi_numa_processor_affinity_init(struct acpi_table_processor_affinity *pa)
+acpi_numa_processor_affinity_init(struct acpi_srat_cpu_affinity *pa)
{
int pxm, node;
if (srat_disabled())
return;
- if (pa->header.length != sizeof(struct acpi_table_processor_affinity)) {
+ if (pa->header.length != sizeof(struct acpi_srat_cpu_affinity)) {
bad_srat();
return;
}
- if (pa->flags.enabled == 0)
+ if ((pa->flags & ACPI_SRAT_CPU_ENABLED) == 0)
return;
- pxm = pa->proximity_domain;
+ pxm = pa->proximity_domain_lo;
node = setup_node(pxm);
if (node < 0) {
printk(KERN_ERR "SRAT: Too many proximity domains %x\n", pxm);
pxm, pa->apic_id, node);
}
-#ifdef RESERVE_HOTADD
+#ifdef CONFIG_MEMORY_HOTPLUG_RESERVE
/*
* Protect against too large hotadd areas that would fill up memory.
*/
if (mem < 0)
return 0;
- allowed = (end_pfn - e820_hole_size(0, end_pfn)) * PAGE_SIZE;
+ allowed = (end_pfn - absent_pages_in_range(0, end_pfn)) * PAGE_SIZE;
allowed = (allowed / 100) * hotadd_percent;
if (allocated + mem > allowed) {
unsigned long range;
return 1;
}
+static int update_end_of_memory(unsigned long end)
+{
+ found_add_area = 1;
+ if ((end >> PAGE_SHIFT) > end_pfn)
+ end_pfn = end >> PAGE_SHIFT;
+ return 1;
+}
+
+static inline int save_add_info(void)
+{
+ return hotadd_percent > 0;
+}
+#else
+int update_end_of_memory(unsigned long end) {return -1;}
+static int hotadd_enough_memory(struct bootnode *nd) {return 1;}
+#ifdef CONFIG_MEMORY_HOTPLUG_SPARSE
+static inline int save_add_info(void) {return 1;}
+#else
+static inline int save_add_info(void) {return 0;}
+#endif
+#endif
/*
- * It is fine to add this area to the nodes data it will be used later
+ * Update nodes_add and decide if to include add are in the zone.
+ * Both SPARSE and RESERVE need nodes_add infomation.
* This code supports one contigious hot add area per node.
*/
static int reserve_hotadd(int node, unsigned long start, unsigned long end)
{
unsigned long s_pfn = start >> PAGE_SHIFT;
unsigned long e_pfn = end >> PAGE_SHIFT;
- int changed = 0;
+ int ret = 0, changed = 0;
struct bootnode *nd = &nodes_add[node];
/* I had some trouble with strange memory hotadd regions breaking
}
/* This check might be a bit too strict, but I'm keeping it for now. */
- if (e820_hole_size(s_pfn, e_pfn) != e_pfn - s_pfn) {
- printk(KERN_ERR "SRAT: Hotplug area has existing memory\n");
+ if (absent_pages_in_range(s_pfn, e_pfn) != e_pfn - s_pfn) {
+ printk(KERN_ERR
+ "SRAT: Hotplug area %lu -> %lu has existing memory\n",
+ s_pfn, e_pfn);
return -1;
}
/* Looks good */
- found_add_area = 1;
if (nd->start == nd->end) {
- nd->start = start;
- nd->end = end;
+ nd->start = start;
+ nd->end = end;
changed = 1;
- } else {
- if (nd->start == end) {
- nd->start = start;
+ } else {
+ if (nd->start == end) {
+ nd->start = start;
changed = 1;
}
- if (nd->end == start) {
- nd->end = end;
+ if (nd->end == start) {
+ nd->end = end;
changed = 1;
}
if (!changed)
printk(KERN_ERR "SRAT: Hotplug zone not continuous. Partly ignored\n");
- }
+ }
- if ((nd->end >> PAGE_SHIFT) > end_pfn)
- end_pfn = nd->end >> PAGE_SHIFT;
+ ret = update_end_of_memory(nd->end);
if (changed)
printk(KERN_INFO "SRAT: hot plug zone found %Lx - %Lx\n", nd->start, nd->end);
- return 0;
+ return ret;
}
-#endif
/* Callback for parsing of the Proximity Domain <-> Memory Area mappings */
void __init
-acpi_numa_memory_affinity_init(struct acpi_table_memory_affinity *ma)
+acpi_numa_memory_affinity_init(struct acpi_srat_mem_affinity *ma)
{
struct bootnode *nd, oldnode;
unsigned long start, end;
if (srat_disabled())
return;
- if (ma->header.length != sizeof(struct acpi_table_memory_affinity)) {
+ if (ma->header.length != sizeof(struct acpi_srat_mem_affinity)) {
bad_srat();
return;
}
- if (ma->flags.enabled == 0)
+ if ((ma->flags & ACPI_SRAT_MEM_ENABLED) == 0)
return;
- if (ma->flags.hot_pluggable && hotadd_percent == 0)
+
+ if ((ma->flags & ACPI_SRAT_MEM_HOT_PLUGGABLE) && !save_add_info())
return;
- start = ma->base_addr_lo | ((u64)ma->base_addr_hi << 32);
- end = start + (ma->length_lo | ((u64)ma->length_hi << 32));
+ start = ma->base_address;
+ end = start + ma->length;
pxm = ma->proximity_domain;
node = setup_node(pxm);
if (node < 0) {
printk(KERN_INFO "SRAT: Node %u PXM %u %Lx-%Lx\n", node, pxm,
nd->start, nd->end);
+ e820_register_active_regions(node, nd->start >> PAGE_SHIFT,
+ nd->end >> PAGE_SHIFT);
+ push_node_boundaries(node, nd->start >> PAGE_SHIFT,
+ nd->end >> PAGE_SHIFT);
-#ifdef RESERVE_HOTADD
- if (ma->flags.hot_pluggable && reserve_hotadd(node, start, end) < 0) {
+ if ((ma->flags & ACPI_SRAT_MEM_HOT_PLUGGABLE) &&
+ (reserve_hotadd(node, start, end) < 0)) {
/* Ignore hotadd region. Undo damage */
printk(KERN_NOTICE "SRAT: Hotplug region ignored\n");
*nd = oldnode;
if ((nd->start | nd->end) == 0)
node_clear(node, nodes_parsed);
}
-#endif
}
/* Sanity check to catch more bad SRATs (they are amazingly common).
unsigned long s = nodes[i].start >> PAGE_SHIFT;
unsigned long e = nodes[i].end >> PAGE_SHIFT;
pxmram += e - s;
- pxmram -= e820_hole_size(s, e);
- pxmram -= nodes_add[i].end - nodes_add[i].start;
+ pxmram -= absent_pages_in_range(s, e);
if ((long)pxmram < 0)
pxmram = 0;
}
- e820ram = end_pfn - e820_hole_size(0, end_pfn);
+ e820ram = end_pfn - absent_pages_in_range(0, end_pfn);
/* We seem to lose 3 pages somewhere. Allow a bit of slack. */
if ((long)(e820ram - pxmram) >= 1*1024*1024) {
printk(KERN_ERR
/* First clean up the node list */
for (i = 0; i < MAX_NUMNODES; i++) {
- cutoff_node(i, start, end);
+ cutoff_node(i, start, end);
if ((nodes[i].end - nodes[i].start) < NODE_MIN_SIZE) {
unparse_node(i);
node_set_offline(i);
if (!node_online(i))
setup_node_bootmem(i, nodes[i].start, nodes[i].end);
- for (i = 0; i < NR_CPUS; i++) {
+ for (i = 0; i < NR_CPUS; i++) {
if (cpu_to_node[i] == NUMA_NO_NODE)
continue;
if (!node_isset(cpu_to_node[i], nodes_parsed))
if (!acpi_slit)
return a == b ? 10 : 20;
- index = acpi_slit->localities * node_to_pxm(a);
+ index = acpi_slit->locality_count * node_to_pxm(a);
return acpi_slit->entry[index + node_to_pxm(b)];
}
EXPORT_SYMBOL(__node_distance);
+
+int memory_add_physaddr_to_nid(u64 start)
+{
+ int i, ret = 0;
+
+ for_each_node(i)
+ if (nodes_add[i].start <= start && nodes_add[i].end > start)
+ ret = i;
+
+ return ret;
+}
+EXPORT_SYMBOL_GPL(memory_add_physaddr_to_nid);
+