bool
default y
+config LOCKDEP_SUPPORT
+ bool
+ default y
+
+config STACKTRACE_SUPPORT
+ bool
+ default y
+
config SEMAPHORE_SLEEPERS
bool
default y
bool
default y
+config AUDIT_ARCH
+ bool
+ default y
+
source "init/Kconfig"
bool "ACPI NUMA detection"
depends on NUMA
select ACPI
+ select PCI
select ACPI_NUMA
default y
help
can be controlled through /sys/devices/system/cpu/cpu#.
Say N if you want to disable CPU hotplug.
+config ARCH_ENABLE_MEMORY_HOTPLUG
+ def_bool y
config HPET_TIMER
bool
bool "Provide RTC interrupt"
depends on HPET_TIMER && RTC=y
-config GART_IOMMU
- bool "K8 GART IOMMU support"
+# Mark as embedded because too many people got it wrong.
+# The code disables itself when not needed.
+config IOMMU
+ bool "IOMMU support" if EMBEDDED
default y
select SWIOTLB
select AGP
depends on PCI
help
- Support for hardware IOMMU in AMD's Opteron/Athlon64 Processors
- and for the bounce buffering software IOMMU.
- Needed to run systems with more than 3GB of memory properly with
- 32-bit PCI devices that do not support DAC (Double Address Cycle).
- The IOMMU can be turned off at runtime with the iommu=off parameter.
- Normally the kernel will take the right choice by itself.
- This option includes a driver for the AMD Opteron/Athlon64 IOMMU
- northbridge and a software emulation used on other systems without
- hardware IOMMU. If unsure, say Y.
-
-# need this always selected by GART_IOMMU for the VIA workaround
+ Support for full DMA access of devices with 32bit memory access only
+ on systems with more than 3GB. This is usually needed for USB,
+ sound, many IDE/SATA chipsets and some other devices.
+ Provides a driver for the AMD Athlon64/Opteron/Turion/Sempron GART
+ based IOMMU and a software bounce buffer based IOMMU used on Intel
+ systems and as fallback.
+ The code is only active when needed (enough memory and limited
+ device) unless CONFIG_IOMMU_DEBUG or iommu=force is specified
+ too.
+
+config CALGARY_IOMMU
+ bool "IBM Calgary IOMMU support"
+ default y
+ select SWIOTLB
+ depends on PCI && EXPERIMENTAL
+ help
+ Support for hardware IOMMUs in IBM's xSeries x366 and x460
+ systems. Needed to run systems with more than 3GB of memory
+ properly with 32-bit PCI devices that do not support DAC
+ (Double Address Cycle). Calgary also supports bus level
+ isolation, where all DMAs pass through the IOMMU. This
+ prevents them from going anywhere except their intended
+ destination. This catches hard-to-find kernel bugs and
+ mis-behaving drivers and devices that do not use the DMA-API
+ properly to set up their DMA buffers. The IOMMU can be
+ turned off at boot time with the iommu=off parameter.
+ Normally the kernel will make the right choice by itself.
+ If unsure, say Y.
+
+# need this always selected by IOMMU for the VIA workaround
config SWIOTLB
bool
help
kexec is a system call that implements the ability to shutdown your
current kernel, and to start another kernel. It is like a reboot
- but it is indepedent of the system firmware. And like a reboot
+ but it is independent of the system firmware. And like a reboot
you can start any kernel with it, not just Linux.
- The name comes from the similiarity to the exec system call.
+ The name comes from the similarity to the exec system call.
It is an ongoing process to be certain the hardware in a machine
is properly shutdown, so do not be surprised if this code does not
bool "kernel crash dumps (EXPERIMENTAL)"
depends on EXPERIMENTAL
help
- Generate crash dump after being started by kexec.
+ Generate crash dump after being started by kexec.
+ This should be normally only set in special crash dump kernels
+ which are loaded in the main kernel with kexec-tools into
+ a specially reserved region and then later executed after
+ a crash by kdump/kexec. The crash dump kernel must be compiled
+ to a memory address not used by the main kernel or BIOS using
+ PHYSICAL_START.
+ For more details see Documentation/kdump/kdump.txt
config PHYSICAL_START
hex "Physical address where the kernel is loaded" if (EMBEDDED || CRASH_DUMP)
optimal TLB usage. If you have pretty much any version of binutils,
this can increase your kernel build time by roughly one minute.
+config K8_NB
+ def_bool y
+ depends on AGP_AMD64 || IOMMU || (PCI && NUMA)
+
endmenu
#