[PATCH] x86_64: Limit max number of CPUs to 255

[linux-2.6] / arch / x86_64 / Kconfig

diff --git a/arch/x86_64/Kconfig b/arch/x86_64/Kconfig
index 2f9deca31cc93f7ac83cae9d1c7bcb8827431ebf..6fc631457196b871f815a2929b35200f402498b1 100644 (file)
--- a/arch/x86_64/Kconfig
+++ b/arch/x86_64/Kconfig
@@ -323,7 +323,7 @@ config HAVE_ARCH_EARLY_PFN_TO_NID
 
 config NR_CPUS
        int "Maximum number of CPUs (2-256)"
-       range 2 256
+       range 2 255
        depends on SMP
        default "8"
        help
@@ -354,21 +354,6 @@ config HPET_TIMER
          as it is off-chip.  You can find the HPET spec at
          <http://www.intel.com/hardwaredesign/hpetspec.htm>.
 
-config X86_PM_TIMER
-       bool "PM timer" if EMBEDDED
-       depends on ACPI
-       default y
-       help
-         Support the ACPI PM timer for time keeping. This is slow,
-         but is useful on some chipsets without HPET on systems with more
-         than one CPU. On a single processor or single socket multi core
-         system it is normally not required.
-         When the PM timer is active 64bit vsyscalls are disabled
-         and should not be enabled (/proc/sys/kernel/vsyscall64 should
-         not be changed).
-         The kernel selects the PM timer only as a last resort, so it is
-         useful to enable just in case.
-
 config HPET_EMULATE_RTC
        bool "Provide RTC interrupt"
        depends on HPET_TIMER && RTC=y
@@ -444,10 +429,10 @@ config CRASH_DUMP
 config PHYSICAL_START
        hex "Physical address where the kernel is loaded" if (EMBEDDED || CRASH_DUMP)
        default "0x1000000" if CRASH_DUMP
-       default "0x100000"
+       default "0x200000"
        help
          This gives the physical address where the kernel is loaded. Normally
-         for regular kernels this value is 0x100000 (1MB). But in the case
+         for regular kernels this value is 0x200000 (2MB). But in the case
          of kexec on panic the fail safe kernel needs to run at a different
          address than the panic-ed kernel. This option is used to set the load
          address for kernels used to capture crash dump on being kexec'ed
@@ -479,6 +464,14 @@ config SECCOMP
 
 source kernel/Kconfig.hz
 
+config REORDER
+       bool "Function reordering"
+       default n
+       help
+         This option enables the toolchain to reorder functions for a more 
+         optimal TLB usage. If you have pretty much any version of binutils, 
+        this can increase your kernel build time by roughly one minute.
+
 endmenu
 
 #
@@ -592,6 +585,7 @@ source "arch/x86_64/oprofile/Kconfig"
 
 config KPROBES
        bool "Kprobes (EXPERIMENTAL)"
+       depends on EXPERIMENTAL && MODULES
        help
          Kprobes allows you to trap at almost any kernel address and
          execute a callback function.  register_kprobe() establishes