Additional support for intel specific MCE features such as
the thermal monitor.
+config PHYSICAL_START
+ hex "Physical address where the kernel is loaded" if EMBEDDED
+ default "0x100000"
+ help
+ This gives the physical address where the kernel is loaded.
+ Primarily used in the case of kexec on panic where the
+ fail safe kernel needs to run at a different address than
+ the panic-ed kernel.
+
+ Don't change this unless you know what you are doing.
+
+config KEXEC
+ bool "kexec system call (EXPERIMENTAL)"
+ depends on EXPERIMENTAL
+ help
+ kexec is a system call that implements the ability to shutdown your
+ current kernel, and to start another kernel. It is like a reboot
+ but it is indepedent of the system firmware. And like a reboot
+ you can start any kernel with it, not just Linux.
+
+ The name comes from the similiarity to the exec system call.
+
+ It is an ongoing process to be certain the hardware in a machine
+ is properly shutdown, so do not be surprised if this code does not
+ initially work for you. It may help to enable device hotplugging
+ support. As of this writing the exact hardware interface is
+ strongly in flux, so no good recommendation can be made.
+
config SECCOMP
bool "Enable seccomp to safely compute untrusted bytecode"
depends on PROC_FS
endmenu
+source "net/Kconfig"
+
source drivers/Kconfig
source "drivers/firmware/Kconfig"