#include <linux/timer.h>
#include <linux/acpi_pmtmr.h>
#include <linux/cpufreq.h>
+#include <linux/dmi.h>
+#include <linux/delay.h>
+#include <linux/clocksource.h>
+#include <linux/percpu.h>
#include <asm/hpet.h>
+#include <asm/timer.h>
+#include <asm/vgtod.h>
+#include <asm/time.h>
+#include <asm/delay.h>
unsigned int cpu_khz; /* TSC clocks / usec, not used here */
EXPORT_SYMBOL(cpu_khz);
/*
* TSC can be unstable due to cpufreq or due to unsynced TSCs
*/
-int tsc_unstable;
+static int tsc_unstable;
/* native_sched_clock() is called before tsc_init(), so
we must start with the TSC soft disabled to prevent
erroneous rdtsc usage on !cpu_has_tsc processors */
-int tsc_disabled = -1;
+static int tsc_disabled = -1;
/*
* Scheduler clock - returns current time in nanosec units.
/*
* Read TSC and the reference counters. Take care of SMI disturbance
*/
-static u64 __init tsc_read_refs(u64 *pm, u64 *hpet)
+static u64 tsc_read_refs(u64 *pm, u64 *hpet)
{
u64 t1, t2;
int i;
}
/**
- * tsc_calibrate - calibrate the tsc on boot
+ * native_calibrate_tsc - calibrate the tsc on boot
*/
-static unsigned int __init tsc_calibrate(void)
+unsigned long native_calibrate_tsc(void)
{
unsigned long flags;
u64 tsc1, tsc2, tr1, tr2, delta, pm1, pm2, hpet1, hpet2;
return tsc_khz_val;
}
-unsigned long native_calculate_cpu_khz(void)
-{
- return tsc_calibrate();
-}
#ifdef CONFIG_X86_32
/* Only called from the Powernow K7 cpu freq driver */
unsigned long cpu_khz_old = cpu_khz;
if (cpu_has_tsc) {
- cpu_khz = calculate_cpu_khz();
- tsc_khz = cpu_khz;
+ tsc_khz = calibrate_tsc();
+ cpu_khz = tsc_khz;
cpu_data(0).loops_per_jiffy =
cpufreq_scale(cpu_data(0).loops_per_jiffy,
cpu_khz_old, cpu_khz);
DEFINE_PER_CPU(unsigned long, cyc2ns);
-void set_cyc2ns_scale(unsigned long cpu_khz, int cpu)
+static void set_cyc2ns_scale(unsigned long cpu_khz, int cpu)
{
unsigned long long tsc_now, ns_now;
unsigned long flags, *scale;
core_initcall(cpufreq_tsc);
#endif /* CONFIG_CPU_FREQ */
+
+/* clocksource code */
+
+static struct clocksource clocksource_tsc;
+
+/*
+ * We compare the TSC to the cycle_last value in the clocksource
+ * structure to avoid a nasty time-warp. This can be observed in a
+ * very small window right after one CPU updated cycle_last under
+ * xtime/vsyscall_gtod lock and the other CPU reads a TSC value which
+ * is smaller than the cycle_last reference value due to a TSC which
+ * is slighty behind. This delta is nowhere else observable, but in
+ * that case it results in a forward time jump in the range of hours
+ * due to the unsigned delta calculation of the time keeping core
+ * code, which is necessary to support wrapping clocksources like pm
+ * timer.
+ */
+static cycle_t read_tsc(void)
+{
+ cycle_t ret = (cycle_t)get_cycles();
+
+ return ret >= clocksource_tsc.cycle_last ?
+ ret : clocksource_tsc.cycle_last;
+}
+
+#ifdef CONFIG_X86_64
+static cycle_t __vsyscall_fn vread_tsc(void)
+{
+ cycle_t ret = (cycle_t)vget_cycles();
+
+ return ret >= __vsyscall_gtod_data.clock.cycle_last ?
+ ret : __vsyscall_gtod_data.clock.cycle_last;
+}
+#endif
+
+static struct clocksource clocksource_tsc = {
+ .name = "tsc",
+ .rating = 300,
+ .read = read_tsc,
+ .mask = CLOCKSOURCE_MASK(64),
+ .shift = 22,
+ .flags = CLOCK_SOURCE_IS_CONTINUOUS |
+ CLOCK_SOURCE_MUST_VERIFY,
+#ifdef CONFIG_X86_64
+ .vread = vread_tsc,
+#endif
+};
+
+void mark_tsc_unstable(char *reason)
+{
+ if (!tsc_unstable) {
+ tsc_unstable = 1;
+ printk("Marking TSC unstable due to %s\n", reason);
+ /* Change only the rating, when not registered */
+ if (clocksource_tsc.mult)
+ clocksource_change_rating(&clocksource_tsc, 0);
+ else
+ clocksource_tsc.rating = 0;
+ }
+}
+
+EXPORT_SYMBOL_GPL(mark_tsc_unstable);
+
+static int __init dmi_mark_tsc_unstable(const struct dmi_system_id *d)
+{
+ printk(KERN_NOTICE "%s detected: marking TSC unstable.\n",
+ d->ident);
+ tsc_unstable = 1;
+ return 0;
+}
+
+/* List of systems that have known TSC problems */
+static struct dmi_system_id __initdata bad_tsc_dmi_table[] = {
+ {
+ .callback = dmi_mark_tsc_unstable,
+ .ident = "IBM Thinkpad 380XD",
+ .matches = {
+ DMI_MATCH(DMI_BOARD_VENDOR, "IBM"),
+ DMI_MATCH(DMI_BOARD_NAME, "2635FA0"),
+ },
+ },
+ {}
+};
+
+/*
+ * Geode_LX - the OLPC CPU has a possibly a very reliable TSC
+ */
+#ifdef CONFIG_MGEODE_LX
+/* RTSC counts during suspend */
+#define RTSC_SUSP 0x100
+
+static void __init check_geode_tsc_reliable(void)
+{
+ unsigned long res_low, res_high;
+
+ rdmsr_safe(MSR_GEODE_BUSCONT_CONF0, &res_low, &res_high);
+ if (res_low & RTSC_SUSP)
+ clocksource_tsc.flags &= ~CLOCK_SOURCE_MUST_VERIFY;
+}
+#else
+static inline void check_geode_tsc_reliable(void) { }
+#endif
+
+/*
+ * Make an educated guess if the TSC is trustworthy and synchronized
+ * over all CPUs.
+ */
+__cpuinit int unsynchronized_tsc(void)
+{
+ if (!cpu_has_tsc || tsc_unstable)
+ return 1;
+
+#ifdef CONFIG_SMP
+ if (apic_is_clustered_box())
+ return 1;
+#endif
+
+ if (boot_cpu_has(X86_FEATURE_CONSTANT_TSC))
+ return 0;
+ /*
+ * Intel systems are normally all synchronized.
+ * Exceptions must mark TSC as unstable:
+ */
+ if (boot_cpu_data.x86_vendor != X86_VENDOR_INTEL) {
+ /* assume multi socket systems are not synchronized: */
+ if (num_possible_cpus() > 1)
+ tsc_unstable = 1;
+ }
+
+ return tsc_unstable;
+}
+
+static void __init init_tsc_clocksource(void)
+{
+ clocksource_tsc.mult = clocksource_khz2mult(tsc_khz,
+ clocksource_tsc.shift);
+ /* lower the rating if we already know its unstable: */
+ if (check_tsc_unstable()) {
+ clocksource_tsc.rating = 0;
+ clocksource_tsc.flags &= ~CLOCK_SOURCE_IS_CONTINUOUS;
+ }
+ clocksource_register(&clocksource_tsc);
+}
+
+void __init tsc_init(void)
+{
+ u64 lpj;
+ int cpu;
+
+ if (!cpu_has_tsc)
+ return;
+
+ tsc_khz = calibrate_tsc();
+ cpu_khz = tsc_khz;
+
+ if (!tsc_khz) {
+ mark_tsc_unstable("could not calculate TSC khz");
+ return;
+ }
+
+#ifdef CONFIG_X86_64
+ if (cpu_has(&boot_cpu_data, X86_FEATURE_CONSTANT_TSC) &&
+ (boot_cpu_data.x86_vendor == X86_VENDOR_AMD))
+ cpu_khz = calibrate_cpu();
+#endif
+
+ lpj = ((u64)tsc_khz * 1000);
+ do_div(lpj, HZ);
+ lpj_fine = lpj;
+
+ printk("Detected %lu.%03lu MHz processor.\n",
+ (unsigned long)cpu_khz / 1000,
+ (unsigned long)cpu_khz % 1000);
+
+ /*
+ * Secondary CPUs do not run through tsc_init(), so set up
+ * all the scale factors for all CPUs, assuming the same
+ * speed as the bootup CPU. (cpufreq notifiers will fix this
+ * up if their speed diverges)
+ */
+ for_each_possible_cpu(cpu)
+ set_cyc2ns_scale(cpu_khz, cpu);
+
+ if (tsc_disabled > 0)
+ return;
+
+ /* now allow native_sched_clock() to use rdtsc */
+ tsc_disabled = 0;
+
+ use_tsc_delay();
+ /* Check and install the TSC clocksource */
+ dmi_check_system(bad_tsc_dmi_table);
+
+ if (unsynchronized_tsc())
+ mark_tsc_unstable("TSCs unsynchronized");
+
+ check_geode_tsc_reliable();
+ init_tsc_clocksource();
+}
+
projects / linux-2.6 / blobdiff