#ifdef CONFIG_X86_32
u8 apicid_2_node[MAX_APICID];
+static int low_mappings;
#endif
/* State of each CPU */
/*
* Activate a secondary processor.
*/
-void __cpuinit start_secondary(void *unused)
+static void __cpuinit start_secondary(void *unused)
{
/*
* Don't put *anything* before cpu_init(), SMP booting is too
enable_8259A_irq(0);
}
+#ifdef CONFIG_X86_32
+ while (low_mappings)
+ cpu_relax();
+ __flush_tlb_all();
+#endif
+
/* This must be done before setting cpu_online_map */
set_cpu_sibling_map(raw_smp_processor_id());
wmb();
#ifdef CONFIG_X86_32
/* init low mem mapping */
clone_pgd_range(swapper_pg_dir, swapper_pg_dir + KERNEL_PGD_BOUNDARY,
- min_t(unsigned long, KERNEL_PGD_PTRS, KERNEL_PGD_BOUNDARY));
+ min_t(unsigned long, KERNEL_PGD_PTRS, KERNEL_PGD_BOUNDARY));
flush_tlb_all();
-#endif
+ low_mappings = 1;
+
+ err = do_boot_cpu(apicid, cpu);
+ zap_low_mappings();
+ low_mappings = 0;
+#else
err = do_boot_cpu(apicid, cpu);
- if (err < 0) {
+#endif
+ if (err) {
Dprintk("do_boot_cpu failed %d\n", err);
- return err;
+ return -EIO;
}
/*
"forcing use of dummy APIC emulation.\n");
smpboot_clear_io_apic();
#ifdef CONFIG_X86_32
- if (nmi_watchdog == NMI_LOCAL_APIC) {
- printk(KERN_INFO "activating minimal APIC for"
- "NMI watchdog use.\n");
- connect_bsp_APIC();
- setup_local_APIC();
- end_local_APIC_setup();
- }
+ connect_bsp_APIC();
#endif
+ setup_local_APIC();
+ end_local_APIC_setup();
return -1;
}
setup_ioapic_dest();
#endif
check_nmi_watchdog();
-#ifdef CONFIG_X86_32
- zap_low_mappings();
-#endif
}
#ifdef CONFIG_HOTPLUG_CPU
cpu_clear(cpu, cpu_sibling_setup_map);
}
-int additional_cpus __initdata = -1;
+static int additional_cpus __initdata = -1;
static __init int setup_additional_cpus(char *s)
{