#include <linux/kernel.h>
#include <linux/interrupt.h>
+#include <linux/module.h>
#include <asm/geode.h>
-#define F_AVAIL 0x01
-
static struct mfgpt_timer_t {
- int flags;
+ unsigned int avail:1;
} mfgpt_timers[MFGPT_MAX_TIMERS];
/* Selected from the table above */
#define MFGPT_HZ (32768 / MFGPT_DIVISOR)
#define MFGPT_PERIODIC (MFGPT_HZ / HZ)
-#ifdef CONFIG_GEODE_MFGPT_TIMER
-static int __init mfgpt_timer_setup(void);
-#else
-#define mfgpt_timer_setup() (0)
-#endif
-
/* Allow for disabling of MFGPTs */
static int disable;
static int __init mfgpt_disable(char *s)
/* The following udocumented bit resets the MFGPT timers */
val = 0xFF; dummy = 0;
- wrmsr(0x5140002B, val, dummy);
+ wrmsr(MSR_MFGPT_SETUP, val, dummy);
return 1;
}
__setup("mfgptfix", mfgpt_fix);
* In other cases (such as with VSAless OpenFirmware), the system firmware
* leaves timers available for us to use.
*/
-int __init geode_mfgpt_detect(void)
+
+
+static int timers = -1;
+
+static void geode_mfgpt_detect(void)
{
- int count = 0, i;
+ int i;
u16 val;
+ timers = 0;
+
if (disable) {
- printk(KERN_INFO "geode-mfgpt: Skipping MFGPT setup\n");
- return 0;
+ printk(KERN_INFO "geode-mfgpt: MFGPT support is disabled\n");
+ goto done;
+ }
+
+ if (!geode_get_dev_base(GEODE_DEV_MFGPT)) {
+ printk(KERN_INFO "geode-mfgpt: MFGPT LBAR is not set up\n");
+ goto done;
}
for (i = 0; i < MFGPT_MAX_TIMERS; i++) {
val = geode_mfgpt_read(i, MFGPT_REG_SETUP);
if (!(val & MFGPT_SETUP_SETUP)) {
- mfgpt_timers[i].flags = F_AVAIL;
- count++;
+ mfgpt_timers[i].avail = 1;
+ timers++;
}
}
- /* set up clock event device, if desired */
- i = mfgpt_timer_setup();
-
- return count;
+done:
+ printk(KERN_INFO "geode-mfgpt: %d MFGPT timers available.\n", timers);
}
int geode_mfgpt_toggle_event(int timer, int cmp, int event, int enable)
* 6; that is, resets for 7 and 8 will be ignored. Is this
* a problem? -dilinger
*/
- msr = MFGPT_NR_MSR;
+ msr = MSR_MFGPT_NR;
mask = 1 << (timer + 24);
break;
case MFGPT_EVENT_NMI:
- msr = MFGPT_NR_MSR;
+ msr = MSR_MFGPT_NR;
mask = 1 << (timer + shift);
break;
case MFGPT_EVENT_IRQ:
- msr = MFGPT_IRQ_MSR;
+ msr = MSR_MFGPT_IRQ;
mask = 1 << (timer + shift);
break;
wrmsr(msr, value, dummy);
return 0;
}
+EXPORT_SYMBOL_GPL(geode_mfgpt_toggle_event);
int geode_mfgpt_set_irq(int timer, int cmp, int irq, int enable)
{
static int mfgpt_get(int timer)
{
- mfgpt_timers[timer].flags &= ~F_AVAIL;
+ mfgpt_timers[timer].avail = 0;
printk(KERN_INFO "geode-mfgpt: Registered timer %d\n", timer);
return timer;
}
{
int i;
- if (!geode_get_dev_base(GEODE_DEV_MFGPT))
- return -ENODEV;
+ if (timers == -1) {
+ /* timers haven't been detected yet */
+ geode_mfgpt_detect();
+ }
+
+ if (!timers)
+ return -1;
+
if (timer >= MFGPT_MAX_TIMERS)
- return -EIO;
+ return -1;
if (timer < 0) {
/* Try to find an available timer */
for (i = 0; i < MFGPT_MAX_TIMERS; i++) {
- if (mfgpt_timers[i].flags & F_AVAIL)
+ if (mfgpt_timers[i].avail)
return mfgpt_get(i);
if (i == 5 && domain == MFGPT_DOMAIN_WORKING)
}
} else {
/* If they requested a specific timer, try to honor that */
- if (mfgpt_timers[timer].flags & F_AVAIL)
+ if (mfgpt_timers[timer].avail)
return mfgpt_get(timer);
}
/* No timers available - too bad */
return -1;
}
+EXPORT_SYMBOL_GPL(geode_mfgpt_alloc_timer);
#ifdef CONFIG_GEODE_MFGPT_TIMER
static void mfgpt_disable_timer(u16 clock)
{
- u16 val = geode_mfgpt_read(clock, MFGPT_REG_SETUP);
- geode_mfgpt_write(clock, MFGPT_REG_SETUP, val & ~MFGPT_SETUP_CNTEN);
+ /* avoid races by clearing CMP1 and CMP2 unconditionally */
+ geode_mfgpt_write(clock, MFGPT_REG_SETUP, (u16) ~MFGPT_SETUP_CNTEN |
+ MFGPT_SETUP_CMP1 | MFGPT_SETUP_CMP2);
}
static int mfgpt_next_event(unsigned long, struct clock_event_device *);
return 0;
}
-/* Assume (foolishly?), that this interrupt was due to our tick */
-
static irqreturn_t mfgpt_tick(int irq, void *dev_id)
{
+ u16 val = geode_mfgpt_read(mfgpt_event_clock, MFGPT_REG_SETUP);
+
+ /* See if the interrupt was for us */
+ if (!(val & (MFGPT_SETUP_SETUP | MFGPT_SETUP_CMP2 | MFGPT_SETUP_CMP1)))
+ return IRQ_NONE;
+
/* Turn off the clock (and clear the event) */
mfgpt_disable_timer(mfgpt_event_clock);
.name = "mfgpt-timer"
};
-static int __init mfgpt_timer_setup(void)
+int __init mfgpt_timer_setup(void)
{
int timer, ret;
u16 val;
geode_mfgpt_write(mfgpt_event_clock, MFGPT_REG_SETUP, val);
/* Set up the clock event */
- mfgpt_clockevent.mult = div_sc(MFGPT_HZ, NSEC_PER_SEC, 32);
+ mfgpt_clockevent.mult = div_sc(MFGPT_HZ, NSEC_PER_SEC,
+ mfgpt_clockevent.shift);
mfgpt_clockevent.min_delta_ns = clockevent_delta2ns(0xF,
&mfgpt_clockevent);
mfgpt_clockevent.max_delta_ns = clockevent_delta2ns(0xFFFE,
&mfgpt_clockevent);
printk(KERN_INFO
- "mfgpt-timer: registering the MFGT timer as a clock event.\n");
+ "mfgpt-timer: registering the MFGPT timer as a clock event.\n");
clockevents_register_device(&mfgpt_clockevent);
return 0;