void me2_uart_pre_configure (unsigned chan, unsigned cflags, unsigned baud)
{
if (chan == 0) {
- /* Specify that the relevent pins on the chip should do
+ /* Specify that the relevant pins on the chip should do
serial I/O, not direct I/O. */
ME2_PORT1_PMC |= 0xC;
/* Specify that we're using the UART, not the CSI device. */
ME2_PORT1_PFC |= 0xC;
} else if (chan == 1) {
- /* Specify that the relevent pins on the chip should do
+ /* Specify that the relevant pins on the chip should do
serial I/O, not direct I/O. */
ME2_PORT2_PMC |= 0x6;
/* Specify that we're using the UART, not the CSI device. */